Pioneer GEX-500DVB Owner's Manual download pdf (Page 6)

Installing the GEX-500DVB Receiver

Before installing

When installing this product and the other multimedia components, ensure suitable cable routing and that the

required cable length is available.

Allow ample space for plugging the connector plug into and out of the DVB-T tuner when doing the positioning of

the tuner. Video/Audio connections should be located for easy access in future.

 Position both brackets underneath the tuner housing and screw them on using the casing screws supplied.

 Then attached the DVB-T receiver at a suitable point using the self-tapping screws provided.

 As an alternation to fasten with screws (recommended), the Velcro strips supplied can be used to fasten

the DVB-T receiver.

Infrared Remote Sensor (IR receiver)

Installing location

Location for installing can be anywhere but make sure there are no objects in between the IR receiver and remote

control during normal control from the user’s position.

1. Determine the installation position for the IR receiver.

To prevent injury in the event of an accident. Do not install components in the inflation range of the

airbag or in areas where the head or knees may knock against them.

2.Use methyl alcohol (spirit) to clean installation surfaces.

3.Remove protective foil from the underside of the adhesive pad, place IR receiver in the desired position and press

it down firmly.

Note: installation temperature should be at least 25



Celsius so that the adhesive pad can develop its full adhesive

strength.

INSTALLATION

1 2 3 4 5 6 7 8 9 10 11 ... 45 46

No comments

Pioneer GEX-500DVB Owner's Manual Page 6