Pioneer BDP-51FD User Manual download pdf (Page 20)

•When S-Video/Video or Component Video is selected at

Video, no sound is output if HDMI is selected at Audio (the

warning message shown below is displayed).

Follow the procedure below to redo the connections, then select

the proper connection at the setup screen.

– When connecting using component video cables, an S-Video

cable or a video cable to watch the picture, connect to an AV

receiver or amplifier, or a TV using either analog audio cables

(7.1 channels or 2 channels), an optical digital audio cable or

a coaxial digital audio cable (page 17).

– When connecting the player to an AV receiver or amplifier

using an HDMI cable in order to listen to the Dolby TrueHD,

Dolby Digital Plus, DTS-HD Master Audio or DTS-HD High

Resolution Audio signals converted into linear PCM, connect

the TV to the AV receiver or amplifier using an HDMI cable

(pages 13 and 16).

• Linear PCM audio signals (2 channels) are output from all

terminals other than the ones selected for Audio, regardless of

the audio format or the player’s settings.

5 Select and set the HDMI High-Speed Transmission setting.

Use / to select, then press ENTER.

When HDMI High-Speed Transmission is set to On, use a High

Speed HDMI™ cable. The picture and sound may not be output

properly if any other HDMI cable (standard HDMI™ cable) is used.

Proceed to step 8.

6 Select the output video resolution from the COMPONENT

VIDEO output terminals.

Use / to select, then press ENTER.

For details on the resolution settings, see Switching the output video

resolution on page 24.

7 Select the aspect ratio of your TV.

Use / to select, then press ENTER.

8 Check the settings.

Select Proceed, then press ENTER.

9 Output test tones.

Use / to select Yes, then press ENTER.

Caution

• The screen in step 10 and test tones are output simultaneously

according to the settings in steps 4 to 7. Lower the volume of the

devices connected with the player.

Go Back

Audio is not output from HDMI

terminal when S-Video/Video or

Component Video is selected.

Please go back and make the

proper selection again.

TOP MENU

TOOLS

HOME

RETURN

ENTER

Setup Navigator

BD PLAYER

Select the HDMI Hi-speed transmission setting.

Normally select [On] (Recommended).

Select [Off] if the video or audio of HDMI-connected

was not output in the test output.

Off

Setup Navigator

BD PLAYER

Select the output video resolution at the

Component video terminal.

If you select [Source Direct], the output

resolution is determined according to the

video format of the playing source.

Setup Navigator

BD PLAYER

Select the screen aspect ratio to match

your TV.

Setup Navigator

BD PLAYER

Select [Proceed] if you want to start testing

your audio and video settings.

Proceed

Setup Navigator

BD PLAYER

The test tone will be output.

Reduce the volume to an appropriate level.

The video and/or audio may not be output under certain setup.

The setup menu comes back in 30 seconds.

Yes No

51FD_WV_EN.book 20 ページ２００８年８月２６日　火曜日　午前９時５８分

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 71 72

Comments to this Manuals

No comments

Pioneer BDP-51FD User Manual Page 20

Comments to this Manuals

Related products and manuals for Blu-Ray players Pioneer BDP-51FD