Pioneer VSX-LX302 User Manual download pdf (Page 15)

Step2: Connect the Speakers

Standard Connections (Pages 8 to 12)

Connect 12345678 for a 7.1 channel system.

Connect 1234569: for a 5.1.2 channel system. Up

to two powered subwoofers can be connected. The same

signal is output from each of the SUBWOOFER PRE OUT

jacks.

You can also connect both

and

. However, you can

only output audio from one of these at a time. When both

are connected, you can switch which speakers to prioritize.

Press on the remote control (P6) and use "Other" -

"Speakers" to switch between surround back speakers and

height speakers and to switch speakers A and B.

Make sure the exposed wires of the speakers do

not stick out of the speaker terminals when

connecting. If the exposed wires of the speakers

touch the rear panel or the + and – wires touch

each other, the protection circuit will be activated.

> Before Start > Part Names >Install > Initial Setup > Playback > Advanced Manual

Troubleshooting | Supplementary Information, etc.

Speaker B

1/2˝

(12 mm)

a Speaker cable, b Subwoofer cable

Setup

0 Settings for the speaker configuration you have

connected need to be made in "1. Full Auto

MCACC" in Initial Setup (P23).

If any of the connected speakers have an impedance of

4 Ω or more to less than 6 Ω, after completing Initial

Setup, you need to make some settings in the System

Setup menu. Press on the remote controller, and in

the Home displayed set "System Setup" - "Speaker" -

"Configuration" - "Speaker Impedance" to "4ohms".

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 96 97

No comments

Pioneer VSX-LX302 User Manual Page 15