Pioneer GEX-P10XMT User Manual download pdf (Page 4)

Route the antenna cable

When routing the lead inside the trunk

When routing the lead through the top of the door

Note:

• Secure the antenna cable with the supplied clamper where required.

Clamps

Use clamps to secure

the lead where

necessary inside the

vehicle.

Make a U-shaped loop in the lead

on the outside to prevent rainwater

from flowing along the lead into the

interior of the vehicle.

Clamps

Use clamps to secure the

lead where necessary inside

the vehicle.

Waterproof pad

Make sure the waterproof pad

contacts the top of the rubber

packing.

Make a U-shaped loop in the

lead outside the rubber

packing to prevent rainwater

from flowing along the lead

into the interior of the vehicle.

Rubber packing

Installation

Installing the Antenna Unit

Installation using the magnet of antenna

Note:

• If the antenna is mounted on the vehicle’s roof, it can be installed in positions other than those in the

diagram. To ensure the best reception, mount more than six inches away from the edge of the roof.

• If mounted in an exterior location on the vehicle other than the vehicle’s roof, reception may be

poor.

• Do not install inside the vehicle, as reception will be extremely poor.

Secure the antenna cable

clamper

6in. (15.5 cm)

Secure the antenna cable

with the supplied clamper

around here.

1 2 3 4

No comments

Pioneer GEX-P10XMT User Manual Page 4