Pioneer DEQ-P7000 User Manual download pdf (Page 14)

Audio Adjustments

Adjusting 3-band parametric equalizer

For CUSTOM1 and CUSTOM2 equalizer

curves, you can adjust the front, rear and center

equalizer curves separately by selecting a cen-

ter frequency, an equalizer level and a Q factor

for each band.

• A separate CUSTOM1 curve can be created

for each source.

•A CUSTOM2 curve can be created common

to all sources.

• The center speaker largely determines the

sound image and getting the balance right isn’t

easy. We recommend reproducing a 2-ch. audio

(a CD for example) and getting the balance right

among the speakers except for the center, and

then reproducing a 5.1-ch. audio (Dolby Digital

or DTS) and adjusting the center speaker output

to the balance you have already got among the

other speakers.

1 Press AUDIO and hold until SP Set

appears in the display, then press AUDIO to

select PEQ.

After SP Set is displayed, press AUDIO until

PEQ appears in the display.

• You cannot select PEQ when neither CUS-

TOM1 nor CUSTOM2 equalizer curve is

selected.

2 Press 2 or 3 to select the speaker selec-

tion mode.

Each press of 2 or 3 selects the item in the

following order:

FRONT (speakers)—Low (bands)—Low (cen-

ter frequency)—L (equalizer level)—Q.WIDE (Q

factor)

3 Press 5 or ∞ to select the speaker to be

adjusted.

Each press of 5 or ∞ selects the speaker in the

following order:

FRONT (front speakers)—CENTER (center

speaker)—REAR (rear speakers)

• You cannot select speakers whose size is set

OFF.

4 Press 3 and then press 5 or ∞ to select the

equalizer band to be adjusted.

Each press of 5 or ∞ selects the equalizer band

in the following order:

Low (low)—Mid (mid)—High (high)

5 Press 3 and then press 5 or ∞ to select the

center frequency of selected band.

Each press of 5 or ∞ selects the frequency in

the following order:

100—125—160—200—250—315—400—500—

630—800—1k—1.25k—1.6k—2k—2.5k—

3.15k—4k—5k—6.3k—8k (Hz)

6 Press 3 and then press 5 or ∞ to adjust

the equalizer level.

Each press of 5 or ∞ increases or decreases

the equalizer level.

• +6 — –6 is displayed as the level is increased

or decreased.

7 Press 3 and then press 5 or ∞ to select the

desired Q factor.

Each press 5 or ∞ switches between the follow-

ing Q factor:

Q.WIDE (wide)—Q.NAR. (narrow)

• You can adjust parameters for each band of

the other speakers in the same way.

8 Press BAND/ESC to return to the playback

display.

Note

• You can select a center frequency from

among 20 frequencies for each band. You can

change the center frequency in 1/3-octave

steps, but you cannot select frequencies so

that there are intervals shorter than 1 octave

among the three bands’ center frequencies.

En

14

02

Section

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 111 112

Comments to this Manuals

No comments