Pioneer AVIC Z3 Installation Guide download pdf (Page 5)

Before installing this

product

! This product is for vehicles with a 12-volt

battery and negative grounding. Check the

battery voltage of your vehicle before instal-

lation.

! To avoid shorts in the electrical system, be

sure to disconnect the (–) battery cable be-

fore beginning installation.

To prevent damage

! When disconnecting a connector, pull the

connector itself. Do not pull the lead, as

you may pull it out of the connector.

! This product cannot be installed in a vehi-

cle without ACC (accessor y) position on

the ignition switch.

A

C

C

O

N

S

T

A

R

T

O

F

F

O

N

S

T

A

R

T

O

F

F

ACC position No ACC position

! When replacing the fuse, be sure to only

use a fuse of the rating prescribed on the

fuse holder.

! To avoid a short-circuit, cover the discon-

nected lead with insulating tape. Insulate

the unused speaker leads without fail.

There is a possibility of a short-circuit if the

leads are not insulated.

! Attach the connectors of the same color to

the corresponding colored port, i.e., blue

connector to the blue port, black to black,

etc.

! Refer to the owner’s manual for details on

connecting the power amp and other units,

then make connections accordingly.

! Since a unique BPTL circuit is employed,

do not directly ground the * side of the

speaker lead or connect the * sides of the

speaker leads together. Be sure to connect

the * side of the speaker lead to the *

side of the speaker lead on this navigation

system.

! If the RCA pin jack on this product will not

be used, do not remove the caps attached

to the end of the connector.

! Speakers connected to this navigation unit

must be high-power with minimum rating

of 50 W and impedance of 4 to 8 ohms.

Connecting speakers with output and/or

impedance values other than those noted

here may result in the speakers catching

fire, emitting smoke, or becoming da-

maged.

Notice for the blue lead

! A signal is output through the blue lead to

control the antenna of your vehicle. The

timing varies depending on the setting. (For

more detailed information on changing

[Auto ANT] mode, refer to the operation

manual.)

! When [Auto ANT] mode is set to [Radio],

the vehicle’s antenna can be stowed or

turned off by following the instructions

below.

— Change the source from radio (AM or

FM) to another source

— Turn the source off

— Turn off the ignition switch (ACC OFF)

Connecting the System

En

5

English

Section

02

1 2 3 4 5 6 7 8 9 10 ... 58 59

Comments to this Manuals

No comments