Pioneer DEX-P99RS Installation Manual download pdf (Page 3)

English

Connecting the units

— Place all cables away from moving parts, such

as gear shift and seat rails.

— Place all cables away from hot places, such as

near the heater outlet.

— Do not pass the yellow cable through a hole

into the engine compartment to connect to a

battery.

— Cover any disconnected cable connectors with

insulating tape.

— Do not shorten any cables.

— Never cut the insulation of the power cable of

this unit in order to share the power to other

equipment. Current capacity of the cable is

limited.

— Use a fuse of the rating prescribed.

— Never wire the speaker negative cable directly

to ground.

• Control signal is output through blue/white cable

when this unit is powered on. Connect it to an

external power amp’s system remote control or

the vehicle’s auto-antenna relay control terminal

(max. 300 mA, 12 V DC). If the vehicle is equipped

with a glass antenna, connect it to the antenna

booster power supply terminal.

• Never connect blue/white cable to external power

amp’s power terminal. Also, never connect

it to the power terminal of the auto antenna.

Otherwise, battery drain or malfunction may

result.

• IP-BUS connectors are color-coded. Be sure to

connect connectors of the same color.

• Black cable is ground. This cable and other

product’s ground cable (especially, high-current

products such as power amp) must be wired

separately. Otherwise, fire or malfunction may

result if they are accidentally detached.

• Refer to the owner’s manual for details on

connecting the power amp and other units, then

make connections correctly.

• If the RCA pin jack on the unit will not be used,

do not remove the caps attached to the end of the

connector.

• When connecting tweeters, please confirm the

tweeter’s usable frequency range. When you set

the cut-off frequency, set higher than the lowest

usable frequency of the tweeter.

• Auto TA uses higher range than 10 kHz for

measurement. Therefore, using the tweeter

that cannot reproduce 10 kHz frequency range

may damage the tweeter. When Auto TA&EQ is

operated, be sure to set the appropriate cut-

off frequency. Also, use the tweeter that can

reproduce 10 kHz at the lowest usable frequency.

1 2 3 4 5 6 7 8 ... 98 99

Comments to this Manuals

No comments

Pioneer DEX-P99RS Installation Manual Page 3

Comments to this Manuals

Related products and manuals for Car media receivers Pioneer DEX-P99RS