Pioneer AVH-5200BT User Manual download pdf (Page 10)

10

<CRD4481-A/N> <10>

Installation

2. Install the unit into the dashboard.

Insert the mounting sleeve into the

dashboard. And then secure the mounting

sleeve by using a screwdriver to bend the

metal tabs (90°) into place.

182

53

Dashboard

Side bracket

Screw (2 mm × 3 mm)

Mounting sleeve

DIN Rear-mount

1. Determine the appropriate position

where the holes on the bracket and

the side of the unit match.

• When installing in a shallow space, use the

following screw holes.

*1 Use binding screws (4 mm × 3 mm) only.

*1

*1

2. Tighten two screws on each side.

Use any of binding screws (4 mm × 3 mm),

binding screws (5 mm × 6 mm) or flush

surface screws (5 mm × 6 mm), depending

on the shape of screw holes in the bracket.

Screw

Dashboard or

Console

Factory radio mounting

bracket

Removing the unit

Extend top and bottom of the trim ring

outwards to remove the trim ring. And then

loosen the screws (2 mm × 3 mm) to remove

the mounting sleeve.

• When reattaching the trim ring, push the

trim ring onto the unit until it clicks after

reattaching the mounting sleeve. (If the trim

ring is attached upside down, the trim ring will

not fit properly.)

Mounting sleeve

Trim ring

Screw (2 mm × 3 mm)

Fastening the front panel

If you do not plan to detach the front panel,

the front panel can be fastened with supplied

screw.

Screw

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 63 64

Comments to this Manuals

No comments