Pioneer DVH-P7000R User Manual download pdf (Page 12)

Installation with the rubber bush

Fig. 9

Holder

After inserting the holder into the

dash-board, then select the

appropriate tabs according to the

thickness of the dash-board

material and bend them.

(Install as firmly as possible using

the top and bottom tabs. To secure,

bend the tabs 90 degrees.)

182

53

Rubber bush

Screw

Dashboard

Installation

Notes

• Before finally installing the unit, connect the

wiring temporarily, making sure it is all con-

nected up properly, and the unit and the sys-

tem work properly.

• Use only the parts included with the unit to

ensure proper installation. The use of unau-

thorized parts can cause malfunctions.

• Consult with your nearest dealer if installation

requires the drilling of holes or other modifi-

cations of the vehicle.

• Install the unit where it does not get in the

driver’s way and cannot injure the passenger

if there is a sudden stop, like an emergency

stop.

• The semiconductor laser will be damaged if it

overheats, so don’t install the unit anywhere

hot — for instance, near a heater outlet.

• If installation angle exceeds 30° from horizon-

tal, the unit might not give its optimum perfor-

mance. (Fig. 7)

Fig. 7

• The cords must not cover up the area shown

in the figure below. This is necessary to allow

the amplifires to radiate freely. (Fig. 8)

Fig. 8

Do not close this area.

En

12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 75 76

Comments to this Manuals

No comments