Pioneer FH-P4200MP User Manual download pdf (Page 37)

Adjusting subwoofer (low pass

filter) settings

When the subwoofer output is on, you can ad-

just the cut-off frequency and the output level

of the subwoofer.

1 Press AUDIO to select 80 : 0.

Press AUDIO until 80 : 0 (subwoofer cut-off

frequency) appears in the display.

# When the subwoofer output is on, you can se-

lect 80 : 0.

# If the subwoofer setting has been previously

adjusted, the frequency of that previously se-

lected will be displayed instead of 80 : 0.

2 Press c or d to select cut-off frequency.

Each press of c or d selects cut-off frequen-

cies in the following order:

506380100125 (Hz)

Only frequencies lower than those in the se-

lected range are outputted from the subwoo-

fer.

3 Press a or b to adjust the output level

of the subwoofer.

Each press of a or b increases or decreases

the level of the subwoofer. +6  24 is dis-

played as the level is increased or decreased.

Press a or b until you see the desired value

displayed.

Adjusting low pass filter

attenuation slope

When the subwoofer output is on, you can ad-

just the continuity of sound between speaker

units.

1 Press AUDIO to select the slope setting.

Press AUDIO until SLOPE appears in the dis-

play.

# When the subwoofer output is on, you can se-

lect SLOPE.

2 Press c or d to select slope.

Press c and SLOPE: 12 is displayed. Press d

and SLOPE: 18 is displayed.

Note

When slope of subwoofer and high pass filter are

SLOPE: 12, and same cut-off frequency, the

phase is reversed 180 degrees at the cut-off fre-

quency. In this case, reversing the phase assures

improved sound continuity.

Using the high pass filter

When you do not want low sounds from the

subwoofer output frequency range to play

from the front or rear speakers, use the HPF

(high pass filter) . Only frequencies higher

than those in the selected range are output

from the front or rear speakers. You can set up

front and rear separately.

1 Press AUDIO to select F-HPF or R-HPF.

Press AUDIO until F-HPF (front high pass filter

cut-off frequency) or R-HPF (rear high pass fil-

ter cut-off frequency) appears in the display.

2 Press a to turn high pass filter on.

F-HPF or R-HPF appears in the display. High

pass filter is now on.

# To turn high pass filter off, press b.

3 Press c or d to select cut-off frequency.

Each press of c or d selects cut-off frequen-

cies in the following order:

506380100125 (Hz)

Only frequencies higher than those in the se-

lected range are output from the front or rear

speakers.

Audio Adjustments

En

37

English

Section

09

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 115 116

Comments to this Manuals

No comments