Pioneer DCS-353 User Manual download pdf (Page 42)

Additional information10

Tuner

USB connection

HDMI connection

(U.K. model only)

Problem

Remedy

Considerable noise in

radio broadcasts.

• Connect the AM antenna (refer to the Setup Guide) and adjust the direction and

position for best reception. You may also connect an additional internal or external

AM antenna (refer to

Connecting auxiliary audio components

on page 31).

• Fully extend the FM wire antenna, position for best reception, and secure to a

wall. You may also connect an outdoor FM antenna (see

Connecting external

antennas

on page 31).

• Turn off other equipment that may be causing the noise or move it further away.

•

Australian model only –

The tuning interval is incorrect for your country or

region. See

Frequency step setting

on page 39 to switch the tuning interval.

Auto tuning does not

pick up some stations.

• The radio signal is weak. Auto tuning will only detect radio stations with a good

signal. For more sensitive tuning, connect an outdoor antenna.

Problem

Remedy

USB mass storage

device is not recognized

by the system.

• Make sure you have completely inserted the USB connector to this unit.

• Check that the memory format is FAT16 or FAT32.

• USB devices with an internal USB hub are not supported.

Files don’t show up in

the Navigator/Photo

Browser.

• The files must have the correct file extension: .mp3 for MP3 files; .wma for WMA

files; .m4a for MPEG-4 AAC files; .jpg for JPEG files (upper or lower-case is OK).

• Make sure the file permission hasn’t been restricted (through a password, etc.).

Can’t play WMA or

MPEG-4 AAC files.

• The files were recorded using DRM (digital rights management) or FairPlay copy-

protection. This is not a malfunction.

Problem

Remedy

No HDMI audio output. • See

Switching the HDMI audio setting

on page 34 to make sure that

AUDIO ON

is selected.

No HDMI video output • Make sure that you’ve selected this player as the HDMI input in the settings for

the component you’re using (refer to the component’s instruction manual).

• Check that the HDMI cable is connected properly and isn’t damaged.

• Check that components connected using the HDMI interface are switched on

and HDMI compatible. (components must be compatible with both DVI and High

Bandwidth Digital Content Protection (HDCP).)

• This unit has been designed to be compliant with HDMI Version 1.1. Depending

on the component you have connected, using a DVI connection may result in

unreliable signal transfers.

• Make sure the resolution on this player matches that of the component you have

connected using HDMI (see

Video Output settings

on page 26).

• If the screen goes blank after changing the resolution, it means the you selected

a resolution incompatible with your monitor. See

Resetting the HDMI connection

on page 34 to reset to the factory defaults.

XV-DV353_360_151_252.book 42 ページ２００５年１２月２０日　火曜日　午後４時８分

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 48

Comments to this Manuals

No comments

Pioneer DCS-353 User Manual Page 42

Comments to this Manuals

Related products and manuals for Home cinema systems Pioneer DCS-353