Pioneer PRO-1120HD User Manual download pdf (Page 20)

06 Preparation

Preparing the remote control unit

Inserting batteries

Open the battery cover.

Insert the supplied two AA size batteries.

• The battery polarities must correspond with the (+) and

(–) indicators in the battery compartment.

Close the battery cover.

Cautions regarding batteries

• The remote control unit cannot operate the system if the

batteries in the unit are empty. When this happens, replace

the batteries with new ones.

• Do not use manganese batteries. When you replace the

batteries, use alkaline ones.

• Do not mix batteries of different types. Different types of

batteries have different characteristics.

• Do not mix old and new batteries. Mixing old and new

batteries can shorten the life of new batteries or cause

chemical leakage in old batteries.

• Do not leave dead batteries in the remote control unit;

chemical leakage will occur. If you find any chemical leakage,

wipe thoroughly with a cloth.

• The batteries supplied with this product may have a shorter

life expectancy due to storage conditions.

• If you will not use the remote control unit for an extended

period of time, remove the batteries from it.

• WHEN DISPOSING OF USED BATTERIES, BE SURE

TO COMPLY WITH GOVERNMENT REGULATIONS

AND ENVIRONMENTAL PROTECTION GUIDELINES

THAT APPLY IN YOUR COUNTRY OR AREA.

Allowed operation range of the remote control

unit

Operate the remote control unit while pointing it toward the

remote control sensor located at the bottom right of the front

panel of the Plasma Display. The distance from the remote

control sensor must be within 7 m (23 feet) and the angle

relative to the sensor must be within 30 degrees in the right or

left direction.

30°

Remote control

sensor

7 m (23 feet)

30°

Cautions regarding the remote control unit

• Do not expose the remote control unit to shock, liquid, or

high humidity.

• Do not place the remote control unit under direct sunlight;

the unit may deform.

• The remote control unit may not work properly if the remote

sensor window of the Plasma Display is under direct sunlight

or strong lighting. In such case, change the angle of the

lighting or Plasma Display, or operate the remote control unit

closer to the remote sensor window.

• When any obstacle exists between the remote control unit

and the remote control sensor, the remote control unit may

not function.

• As the batteries become empty, the remote control unit can

function within a shorter distance from the remote control

sensor. Replace the batteries with new ones if necessary.

• The Plasma Display emits very weak infrared rays from its

screen. If you place such equipment operated through

infrared remote control as a VCR nearby, that equipment may

not receive commands from its remote control unit properly

or entirely. If this is the case, place that equipment at a

location far enough from the Plasma Display.

• Depending on the installation environment, infrared rays

from the Plasma Display may not allow this system to

properly receive commands from the remote control unit or

may shorten allowable distances between the remote control

unit and the remote control sensor. The strength of infrared

rays emitted from the screen differs, depending on images

displayed on the screen.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 80 81

Comments to this Manuals

No comments

Pioneer PRO-1120HD User Manual Page 20

Comments to this Manuals

Related products and manuals for LCD TVs Pioneer PRO-1120HD