13
En
Connections and part names
1 FX CH SELECT control
Switches the channel to which the effect is applied.
!
Effects applied to the MIC/AUX channel cannot be used with
Serato DJ ver. 1.2. They are scheduled to be supported with
future version upgrades.
2 EFFECT SELECT control
Selects the type of effect.
3 BEATS (PARAMETER) control
Adjusts the effect time.
[SHIFT] + turn:
Adjusts the effect’s parameter 3.
4 LEVEL/DEPTH control
Adjusts the effect’s parameter 1.
5 FX ON/OFF button
Turns the effect on/off.
6 TAP/AUTO (FX MODE) button
Press:
The BPM used as the base value for the effect is calculated by the
interval at which the button is tapped with a finger.
When the button is pressed and held, the effect time is reset.
[SHIFT] + press:
Switches the effect mode from the single mode to the multi mode.
When the [SHIFT] and [TAP/AUTO (FX MODE)] buttons are pressed
again, the effect mode returns to the single mode.
To monitor the effect sounds
When the [HEADPHONES MIXING] control is turned to the [CUE]
side, the Serato DJ software’s effect sounds are not output to the
sound of the channels whose headphones [CUE] button are pressed.
If you want to monitor the Serato DJ software’s effect sounds, turn the
[HEADPHONES MIXING] control to the [MASTER] side and monitor the
effect sounds in the sound of the master output.
Microphone/External input control section
LEVEL
MAXMIN
OFF ON
TALK
OVER
MIC 2 / AUX
LOW
MAXMIN
MID
EQ
MAXMIN
HI
INPUT
SELECT
MAXMIN
AUXMIC 2
LEVEL
MAXMIN
OFF ON
TALK
OVER
MIC 1
LOW
MAXMIN
MID
EQ
MAXMIN
HI
MAXMIN
MIC 1
1 23 4
1 OFF, ON, MIC TALK OVER selector switch
Turns the microphone on/off.
= Using a microphone (p.21)
2 LEVEL control
Adjusts the level of the output sound.
3 EQ (HI, MID, LOW) controls
Boosts or cuts frequencies in order to change the quality of the
sound.
4 MIC2/AUX selector switch
Switches the audio input between the microphone and the external
device.
! [MIC2]: Selects the microphone connected to the [MIC2]
terminal.
!
[AUX]: Selects the external device connected to the [AUX IN]
terminals.
= Using a microphone (p.21)
= Using an external device (p.21)
Using the LAPTOP DOCK
The computer’s keyboard section can be stowed under this unit.
! Depending on the size of your (notebook) computer, the keyboard
section may not fit in the LAPTOP DOCK.
! Install in such a way that the computer unit does not touch this unit.
! Install in such a way that the cables connected to the computer are
not stuck under this unit.
Using with the feet removed
This unit’s two feet can be removed.
Use a Phillips screwdriver to remove the screws from the
left and right feet (2 screws each).
! The screws you have removed will be needed when mounting
the feet. Be careful not to lose them. The feet cannot be properly
mounted using other screws.
Comments to this Manuals