Pioneer PDP-614MX User Manual download pdf (Page 6)

English

Installation

(2")

(2") 50

(2")

Wall

(2")

You can attach your optional mounts or stand to the plasma monitor in one of the following two ways:

* While it is upright. (See Drawing A)

* As it is laid down with the screen face down (See Drawing B). Lay the protective sheet, which was wrapped around the

monitor when it was packaged, beneath the screen surface so as not to scratch the screen face.

* Do not touch or hold the screen face when carrying the unit.

• This device cannot be installed on its own. Be sure to use a stand or original mounting unit. (Wall

mount unit, Stand, etc.)

* See page 1.

• For correct installation and mounting it is strongly recommended to use a trained, authorized

dealer.

Failure to follow correct mounting procedures could result in damage to the equipment or injury

to the installer.

Product warranty does not cover damage caused by improper installation.

* Use only the mounting kit or stand provided by manufacturer and listed under Options.

Drawing B

Drawing A

When installing or carrying, use the

handles attached to the upper back

of the display.

How to use the safety metal fittings

and the screws for safety metal

fittings

These are fittings for fastening the unit to a wall to prevent

tipping due to external shock when using the stand

(optional). Fasten the safety fittings to the holes in the

back of the monitor using the safety fitting mount screws.

Screw hole

Wall

Table Top

Safty metal fittings

Metal chain

(Not supplied)

Screw or Hook etc.

(Not supplied)

Ventilation Requirements for

enclosure mounting

To allow heat to disperse, leave space between surrounding

objects as shown on the diagram below when installing.

Installation

English

Installation

Note:

1. The VIDEO1 and PC1 terminals can be used for either INPUT or OUTPUT.

When LOOP OUT is ON, do not connect an OUTPUT signal from another unit, that will place an extraordinary load on

the other unit and may damage it.

2. LOOP OUT can not be turned ON while signals are input to the PC1 terminal.

3. LOOP OUT can be turned ON while signals are input to the PC1 terminal if the POWER is switched ON.

Information

• To loop signals out to another plasma display, set the LOOP OUT to ON.

• To create a video wall, set the VIDEO WALL menu items properly.

• To connect monitors, please use a 1~2m (3.3~6.6 feet) BNC cable (any commercially available cable).

• If the image quality is poor, do not use the monitor’s out terminal. Use a distribution amplifier (any commercially

available distribution amplifier) to connect the split signals to the respective monitor INPUT terminals.

• Being used as a video wall function, maximaly 4-screen is rough-standard with lower than 1024768, 60Hz

signal.

• A distribution amplifier is particularly recommended when using 9-screen and over video wall.

• From the second monitor onward, connections require a BNC-RCA conversion cable or connector, a mini D-Sub

15 pin cable-BNC (5) cable or a conversion connector.

Creating a video wall

With built-in matrix display capability, you can create a 4-25 video wall.

• Connect signal cables and remote cables as shown below.

Video signal PC/COMPONENT signal

BNC connector

RCA phono plug

OUT

VIDEO signal

OUT

Remote

control

VIDEO signal

Remote

control

BNC connector

PC signal/

OUT

Remote

control

COMPONENT

PC signal/

COMPONENT

Remote

control

signal

Cable Management

Using the cable clamps provided with the plasma display,

bundle at the back of the unit the signal and audio cables

connected to the display.

Back of the unit

mounting holes

To attach To detach

clamp

mounting hole

cables

1. 2.

1 2 3 4 5 6 7 8 9 10 11 ... 20 21

Comments to this Manuals

No comments

Pioneer PDP-614MX User Manual Page 6

Comments to this Manuals