Pioneer AVIC-F220 User Manual download pdf (Page 18)

After installing this

navigation system

CAUTION

After installing this navigation system, be

sure to check at a safe place that the vehicle

is performing normally.

It may take a few minutes to start up the navi-

gation system when you start up the system

for the first time or the outside temperature is

not within the charging range. Wait until the

battery charging starts.

1 Reconnect the negative (–) terminal of

the vehicle’s battery.

First, double-check that all connections are

correct and that this product is installed cor-

rectly. Reassemble all vehicle components

that you previously removed. Then reconnect

the negative (–) cable to the negative ( –) term-

inal of the battery.

2 Start the engine.

3 Press the RESET button.

Press the RESET button on the navigation unit

with a pointed object such as the tip of a pen.

RESET button

After a short pause, the navigation screen re-

turns.

p If the navigation screen does not return

after a while, press the MODE button of the

AV receiver to switch the screen.

4 Make the following settings.

= For details concerning operations, refer to

Operation Manual.

1 Set the language.

2 Drive an unobstructed road until the GPS

starts receiving the signal normally.

3 Make some necessary adjustments.

! Setting the time

! Change other settings as you prefer

Engb

18

Section

05

After installation

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 111 112

Comments to this Manuals

No comments