Pioneer AVIC-X1R User Manual download pdf (Page 27)

Installing the GPS aerial

• Do not cut the GPS aerial lead to shorten it or use an extension to make it

longer. Altering the aerial cable could result in a short circuit or malfunction

and permanent damage to the product.

Installation notes

• When installing the GPS aerial inside the vehicle, be sure to use the metal sheet

provided with your system. If this is not used, the reception sensitivity will be poor.

• Do not cut the accessory metal sheet. This would reduce the sensitivity of the GPS

aerial.

• Take care not to pull the aerial lead when removing the GPS aerial. The magnet attached

to the aerial is very powerful, and the lead may become detached.

• The GPS aerial is installed with a magnet. When installing the GPS aerial, be careful

not to scratch the vehicle body.

• When installing the GPS aerial on the outside of the vehicle, always put it in the vehicle

when going through an automatic vehicle wash. If it is left on the outside it may be

knocked off and scratch the vehicle body.

• Do not paint the GPS aerial, as this may affect its performance.

Roof

Rear shelf

Boot lid

• The aerial should be installed on a

level surface where radio waves will

be blocked as little as possible. Radio

waves cannot be received by the aerial

if reception from the satellite is

blocked.

Installation on the vehicle roof or boot

lid is recommended to optimise recep-

tion.

ENG/MASTER 96

English

Español

Deutsch

Français

Italiano

Nederlands

<CRD3958A/U> 27

CRD3958A_U_inst001_031_UK 11/12/04 13:09 Page 27

1 ... 26 27 28 ... 181

No comments

Pioneer AVIC-X1R User Manual Page 27