Pioneer GM-6500F User Manual download pdf (Page 7)

! If the system remote control wire of the ampli-

fier is connected to the power terminal via the

ignition switch (12 V DC), the amplifier will re-

main on with the ignition whether the car

stereo is on or off, which may exhaust battery

if the engine is at rest or idling.

! Install and route the separately sold battery

wire as far as possible from the speaker wires.

Install and route the separately sold battery

wire, ground wire, speaker wires and the am-

plifier as far away as possible from the anten-

na, antenna cable and tuner.

About bridged mode

Speaker impedance is max. 4 W, please carefully

check. Improper connection to the amplifier may

result in malfunction or personal injury due to

burns from overheating.

For bridged mode for a two-channel amplifier,

with a 4 W load, either wire two 8 W speakers in

parallel, Left + and Right * (Diagram A) or use a

single 4 W speaker. For other amplifiers, please

follow the speaker output connection diagram for

bridging shown on rear: two 8 W speakers in par-

allel for a 4 W load or a single 4 W speaker per

channel.

For any further enquiries, contact your local

authorized Pioneer dealer or customer service.

About suitable

specification of speaker

Ensure speakers conform to the following

standards, otherwise there is a risk of fire,

smoke or damage. Speaker impedance is 2 W

to 8 W,or4W to 8 W for two-channel and other

bridge connections.

Subwoofer

Speaker channel Power

Four-channel output

Nominal input:

Min. 60 W

Two-channel output

Nominal input:

Min. 180 W

Three-channel

Speaker output A

Nominal input:

Min. 60 W

Three-channel

Speaker output B

Nominal input:

Min. 180 W

Other than subwoofer

Speaker channel Power

Four-channel output

Max. input:

Min. 120 W

Two-channel output

Max. input:

Min. 360 W

Three-channel

Speaker output A

Max. input:

Min. 120 W

Three-channel

Speaker output B

Max. input:

Min. 360 W

Connecting the speakers

The speaker output mode can be four-channel,

three-channel (stereo and mono) or two-chan-

nel (stereo or mono). Connect the speaker

leads based on the mode and the figures

shown below.

En

7

English

Section

03

Connecting the units

1 2 3 4 5 6 7 8 ... 96

Comments to this Manuals

No comments