Pioneer DEH-P6400R User Manual download pdf (Page 38)

Initial Settings

Switching the dimmer setting

To prevent the display from being too bright at

night, the display is automatically dimmed

when the car’s headlights are turned on. You

can switch dimmer on or off.

1 Press

FUNCTION to select DIM.

Press

FUNCTION repeatedly until Dimmer

appears in the display.

2 Select DIM on or off with 5/∞.

Pressing 5/∞ will switch Dimmer between on

and off and that status will be displayed (e.g.,

Dimmer :ON).

Selecting the brightness

You can select the display brightness. Initially

this mode is set to 12.

1 Press FUNCTION to select BRIGHT.

Press FUNCTION repeatedly until Brightness

appears in the display.

2 Select the desired brightness with 2/3.

• The display shows 0 – 15.

Switching the rear output setting

This unit’s rear output (rear speaker leads out-

put and RCA rear output) can be used for full-

range speaker or subwoofer connection. If you

switch the rear output setting to the subwoofer,

you can connect a rear speaker lead directly to a

subwoofer without using an auxiliary amp.

• If you connect a subwoofer to the rear output,

set the output setting to subwoofer.

• Even if you change this setting, there is no

output unless you switch the subwoofer out-

put on (refer to Using subwoofer output on

page 34).

• Both rear speaker leads output and RCA rear

output are switched simultaneously in this

setting.

1 Press FUNCTION to select SW.

Press FUNCTION repeatedly until FRT+REAR

appears in the display.

2 Select full-range speaker or subwoofer

with 2/3.

Pressing 2/3 will switch between FRT+REAR

(full-range speaker) and FRT+SW (subwoofer)

and that status will be displayed.

En

38

08

Section

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 95 96

Comments to this Manuals

No comments