Pioneer HTS-260 User Manual download pdf (Page 18)

Getting started

3 If the receiver subwoofer is off, press



STANDBY/

to turn the power on.

4 Press

MCACC

Try to be as quiet as possible after pressing

MCACC

. The

volume increases automatically and the system outputs

a series of test tones.

• To cancel Auto MCACC setup before it has finished,

press

MCACC

. The unit will continue to use the

previous settings.

• If the ambient noise level is too high,

NOISY

blinks in

the display for five seconds. To exit and check the

noise levels

, press

MCACC

, or to try again, press

ENTER

when

RETRY

shows in the display.

• If you see an

ERR MIC

ERR SP

message in the

display, there may be a problem with your mic or the

speaker connections. To try again, press

ENTER

when you see

RETRY

When the MCACC setup is complete, the volume level

returns to normal,

COMPLETE

shows in the display, and

Acoustic Calibration EQ is activated.

Note

1• If the room environment is not optimal for the Auto MCACC setup (too much ambient noise, echo off the walls, obstacles blocking the speakers from

the microphone) the final settings may be incorrect. Check for household appliances (air conditioner, fridge, fan, etc.), that may be affecting the environ-

ment and switch them off if necessary.

• Some older TVs may interfere with the operation of the mic. If this seems to be happening, switch off the TV during Auto MCACC setup.

2 If this doesn’t work, press

MCACC

, turn off the power, and check the problem indicated by the

ERR

message, then try the Auto MCACC setup again.

3 If

COMPLETE

doesn’t appear, it is likely an error occurred during the setup. Please check all connections and try again.

4 See

Listening with Acoustic Calibration EQ

on page 21 to switch on/off Acoustic Calibration EQ.

SX-SW260_KU.book Page 18 Wednesday, March 29, 2006 2:43 PM

1 ... 17 18 19 ... 72

Comments to this Manuals

No comments

Pioneer HTS-260 User Manual Page 18

Comments to this Manuals