11
En
English
Attaching the Plasma Television
The weight of a 50 inch model (without speakers) is
about 34 kg (74 lbs), that of 42 inch model is about
30 kg (66 lbs), they have no depth, and are unstable.
Therefore, at least two people must assemble and
install them.
Note
Be sure to install it on a flat stable location.
Insert the screws in the holes vertically and do not tighten
them with more force than necessary.
Place a sheet or other material under the display to
prevent scratches or damage to it.
After manually turning the screw lightly two or three
times, tighten it with a screw-driver.
1 Attaching the plasma television to the
stand.
Lay the plasma television down flat. Align the stand
supports with the plasma television stand slots, and slowly
insert the supports horizontally.
Please ensure that the stand supports do not come into
contact with anything other than the plasma television
stand slots. Contact with any other area may result in
scratching or deformation of the display's rear side or
terminals.
Note
When laying down the plasma television, be careful so as to
not scratch or damage it.
2 Securing the plasma television with
Installation screws 2 (M8 × 60 mm: black)
or 3 (M8 × 40 mm: black).
Secure the parts marked with the arrows (holes marked
"T") using a Phillips screwdriver.
[42 inch display model]
PDK-TS27/PDK-TS27A
................ Installation screw 2 (M8 × 60 mm: black)
[50 inch display model]
PDK-TS28/PDK-TS29/PDK-TS29A
................. Installation screw 3 (M8 × 40 mm: black)
3 Securing the plasma television with
Installation screws 4 (M8 × 23 mm: black).
Please tighten the screws with a Phillips screwdriver.
Note
Please stand the plasma television upright after installing the
stand.
Caution
Installation
screws
2 or 3
Front
Rear
Installation screws 4
(M8 × 23 mm: black)
Front
Rear
Front
Rear
Comments to this Manuals