Pioneer VSX-819H-S User Manual download pdf (Page 44)

The System Setup menu06

• Surr. Back – Select the number of

surround back speakers you have (one, two

or none).

Select LARGE if your surround

back speakers reproduce bass frequencies

effectively. Select SMALL to send bass

frequencies to the other speakers or

subwoofer. If you didn’t connect surround

back speakers choose NO.

• Subwoofer – LFE signals and bass

frequencies of channels set to SMALL are

output from the subwoofer when YES is

selected (see notes below). Choose the PLUS

setting if you want the subwoofer to output

bass sound continuously or you want deeper

bass (the bass frequencies that would

normally come out the front and center

speakers are also routed to the subwoofer). If

you did not connect a subwoofer

choose NO

(the bass frequ

ncies are output from other

speakers).

3 When you’re finished, press RETURN.

You return to the Manual SP Setup menu.

Tip

• If you have a subwoofer and like lots of

bass, it may seem logical to select LARGE

for your front speakers and PLUS for the

subwoofer. This may not, however, yield the

best bass results. Depending on the

speaker placement of your room you may

actually experience a decrease in the

amount of bass due to low frequency

cancellations. In this case, try changing

the position or direction of speakers. If you

can’t get good results, listen to the bass

response with it set to PLUS an

d YES or th

front speakers set to LARGE and SMALL

alternatively and let your ears judge which

sounds best. If you’re having problems, the

easiest option is to route all the bass

sounds to the subwoofer by selecting

SMALL for the front speakers.

Crossover Network

•Default setting: 100Hz

This setting decides the cutoff between bass

sounds playing back from the speakers

selected as LARGE, or the subwoofer, and bass

sounds playing back from those selected as

SMALL. It also decides where the cutoff will be

for bass sounds in the LFE channel.

1 Select ‘Crossover Network’ from the

Manual SP Setup menu.

2 Choose the frequency cutoff point.

Frequencies below the cutoff point will be sent

to the subwoofer (or LARGE speakers).

3 When you’re finished, press RETURN.

You return to the Manual SP Setup menu.

Channel Level

Using the channel level settings, you can

adjust the overall balance of your speaker

system, an important factor when setting up a

home theater system.

1 Select ‘Channel Level’ from the Manual

SP Setup menu.

Note

1• If the surround speakers are set to NO, the surround back speakers will automatically be set to NO.

• If you select one surround back speaker only, make sure that additional amplifier is hooked up to the PRE OUT SURROUND

BACK L (Single) terminal.

2For more on selecting the speaker sizes, see Speaker Setting on page 43.

2.Manual SP Setup

Return

a.Speaker Setting

b.Crossover Network

c.Channel Level

d.Speaker Distance

2b.Crossover Network

Return

Frequency 100Hz

2.Manual SP Setup

Return

a.Speaker Setting

b.Crossover Network

c.Channel Level

d.Speaker Distance

2c.Channel Level

Test Tone Manual

ENTER:NextReturn

VSX-819H_RLF.book 44 ページ２００９年１月２０日　火曜日　午前１０時３６分

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 210 211

Comments to this Manuals

No comments

Pioneer VSX-819H-S User Manual Page 44

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Pioneer VSX-819H-S