Pioneer AVIC 505 Installation Guide download pdf (Page 7)

Before installing the unit

• This unit is designed for vehicles with a 12-volt battery and negative grounding. Before

installing the system (especially in a recreational vehicle, lorry, or bus), check the bat-

tery voltage.

To prevent damage

• When disconnecting a connector, pull the connector itself. Do not pull the lead, as you

may pull it out of the connector.

Parts supplied

ConnectorPink lead extension cord

Power cord

Purple lead extension cordRGB cable

No ACC position

Fig. 2

ACC position

Fig. 1

• When the unit is installed in vehicles

that do not have an ACC (accessory)

position on the ignition (as shown in

Fig. 2), be sure to connect the red lead

of the unit to the terminal controlled by

the ignition switch ON/OFF position. If

you do not, the vehicle battery may be

drained.

• Disconnect the negative (–) terminal of

the battery to avoid the risk of a short

circuit.

ENGLISH ESPAÑOL DEUTSCH FRANÇAIS

ITALIANO NEDERLANDS

1 2 3 4 5 6 7 8 9 10 11 12 ... 147 148

No comments

Pioneer AVIC 505 Installation Guide Page 7