Pioneer AVH-P6600DVD User Manual download pdf (Page 14)

Resetting the microprocessor

Pressing RESET lets you reset the micropro-

cessor to its initial settings.

The microprocessor must be reset under the

following conditions:

! Prior to using this unit for the first time

after installation

! If the unit fails to operate properly

! When strange or incorrect messages ap-

pear on the display

1 Turn the ignition switch OFF.

2 Press RESET with a pen tip or other

pointed instrument.

RESET button

Notes

! When using with a Pioneer navigation unit, if

you press RESET, be sure ACC OFF is se-

lected. If ACC ON is selected, correct opera-

tion may not be possible even if you press

RESET.

! After completing connections or when you

want to erase all memorized settings or return

the unit to its initial (factory) settings, switch

your engine ON or set the ignition switch to

ACC ON before pressing RESET.

Use and care of the remote

control

Installing the battery

Slide the tray out on the back of the remote

control and insert the battery with the plus (+)

and minus ( ) poles pointing in the proper di-

rection.

! When using for the first time, pull out the

film protruding from the tray.

WARNING

Keep the battery out of the reach of children.

Should the battery be swallowed, immediately

consult a doctor.

CAUTION

! Use only one CR2025 (3 V) lithium battery.

! Remove the battery if the remote control is not

used for a month or longer.

! Do not recharge, disassemble, heat or dispose

of the battery in fire.

! Do not handle the battery with metallic tools.

! Do not store the battery with metallic materi-

als.

! In the event of battery leakage, wipe the re-

mote control completely clean and install a

new battery.

! When disposing of used batteries, please

comply with governmental regulations or en-

vironmental public institutions rules that

apply in your country/area.

Before You Start

En

14

Section

02

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 113 114

Comments to this Manuals

No comments