Pioneer CD/MP3 User Manual download pdf (Page 31)

07

Section

Audio Adjustments

En

31

English

Español

Deutsch

Français

Italiano

Nederlands

Introduction of audio

adjustments

1 AUDIO display

Shows the audio adjustments status.

Press AUDIO to display the audio function

names.

Press AUDIO repeatedly to switch between the

following audio functions:

Fad (balance adjustment)—EQ (equalizer curve

adjustment)—Bass (bass)—Treble (treble)—

Loud (loudness)—Sub-W1 (subwoofer1)/Non Fad

(non fading output on/off)—Sub-W2

(subwoofer2)/Non Fad (non fading output set-

ting)—HPF (high pass filter)—SLA (source level

adjustment)

• When the subwoofer controller setting is only

S.W Control:EXT, you cannot switch the Sub-W1.

(Refer to page 38.)

• You can select the Sub-W2 only when

Subwoofer output is switched on in the Sub-W1.

• When the subwoofer controller setting is only

S.W Control:EXT, you can switch the non fading

output on/off mode. (Refer to page 38.)

• You can select the non fading output setting

mode only when non fading output is switched

on in the non fading output on/off mode.

• When selecting the FM tuner as the source,

you cannot switch to SLA.

• To return to the playback display, press

BAND/ESC.

Note

• If you do not operate the audio function within

about 30 seconds, the display is automatically

returned to the source display.

Setting the sound focus equal-

izer

Clarifying the sound image of vocals and instru-

ments allows the simple staging of a natural,

pleasant sound environment.

Even greater listening enjoyment will be

obtained if seating positions are chosen care-

fully.

• FRT1 boosts the treble on the front output and

the bass on the rear output.

FRT2 boosts the treble and the bass on the front

output and the bass on the rear output. (The

bass boost is the same for both front and rear.)

For both FRT1 and FRT2 the H setting provides a

more pronounced effect than the L setting.

1 Press SFEQ to select the desired SFEQ

mode.

FRT1-H (front1-high) —FRT1-L (front1-low) —

FRT2-H (front2-high) —FRT2-L (front2-low) —

CUSTOM (custom) —SFEQ OFF (off)

2 Press 2 or 3 to select the desired position.

Press 2 or 3 until the desired position appears

in the display.

LEFT (left) —CENTER (center) —RIGHT (right)

Notes

• If you adjust the bass or treble, CUSTOM

memorizes an SFEQ mode in which the bass

and treble are adjusted for personal prefer-

ence.

1

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 95 96

Comments to this Manuals

No comments