Pioneer XDJ-AERO User Manual download pdf (Page 21)

Part names and functions

— When turned clockwise: The volume of the sound output from the

[MASTER OUT 1] and [MASTER OUT 2] terminals (the sound of

the master channel) becomes relatively louder.

4 Turn the [HEADPHONES LEVEL] control.

Sound is output from the headphones.

! When the [

(CH1)] button or [ (CH2)] button is pressed again,

monitoring is canceled.

! Monitoring of the sound output from the [MASTER OUT 1] and

[MASTER OUT 2] terminals (the sound of the master channel) can-

not be canceled.

Using a microphone

1 Press the [MIC (ON/OFF)] button.

2 Turn the [MIC LEVEL] control clockwise.

The sound of the microphone is output from the speakers.

! Adjust the [MIC ATT.] control on the rear panel as necessary (page

10).

 Adjusting the sound quality

Turn the [MIC EQ] control.

— When turned fully clockwise, the attenuation of the bass sound is

maximum.

— When turned fully counterclockwise, the attenuation of the treble

sound is maximum.

Using the filter function

The sound of the high or low range is filtered out, greatly changing the

tone.

Turn the [FILTER] control.

— Right: An effect as if the low range was gradually cut is achieved.

— Left: An effect as if the high range was gradually cut is achieved.

Effect section

FX SELECT

TRANS FLANGER ROLLECHO

LEVEL/DEPTH

BEAT

1 2 3 4

1 32

1 BEAT control

This is used to select the beat multiple to which the effect is

synchronized.

2 FX SELECT (TRANS, FLANGER, ECHO, ROLL) buttons

Turns the effects on and off.

3 LEVEL/DEPTH control

Adjusts the quantitative parameter of the effect.

Using the beat effect function

This unit is equipped with four effect buttons. Effects can be applied to

the sound by pressing one of the effect buttons.

Press one of the [FX SELECT (TRANS, FLANGER, ECHO,

ROLL)] buttons.

The button that was pressed flashes.

The effect is applied in beat with the track.

The effect differs for the different buttons. For details on the different

effects, see the table below.

! When a button that is flashing is pressed again, the effect is turned

off.

Effect Name Descriptions LEVEL/DEPTH

TRANS

Cuts the sound according to

the beat multiple set with the

[BEAT] control.

Sets the balance between

the original sound and the

effect sound.

FLANGER

Creates a one-cycle flanger

effect according to the beat

multiple set with the [BEAT]

control.

The further the control is

turned clockwise, the more

the effect is stressed.

When turned all the way

counterclockwise, only the

original sound is output.

ECHO

Outputs a delay sound

several times that attenuates

gradually according to the

beat multiple set with the

[BEAT] control.

With 1/1 beat echoes, the

delay sounds are faded out

according to the track’s

tempo even after the input

sound has been cut.

Use this to set the balance

between the original sound

and the echo sound.

ROLL

Records the input sound at

the point the [ROLL] button

is pressed and repeatedly

outputs the recorded sound

according to the beat mul-

tiple set with the [BEAT]

control.

Sets the balance between

the original sound and the

roll sound.

 Varying the effect

Turn the [LEVEL/DEPTH] control.

The effect changes according to the direction in which the

[LEVEL/DEPTH] control is turned and its position.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 36 37

Comments to this Manuals

No comments

Pioneer XDJ-AERO User Manual Page 21

Comments to this Manuals

Related products and manuals for DJ controllers Pioneer XDJ-AERO