Pioneer DCS-580 Operations Instructions download pdf (Page 17)

Listening to your system 03

17

En

2Use

/

to select EQ ON or EQ OFF

then

press ENTER to confirm

.

•If you select EQ OFF, equalization is set to

off but speaker settings (channel delay and

channel level) remain in effect.

•

EQ ON

is selected automatically after the

Auto MCACC setup is completed.

Using the Sound Retriever

When audio data is removed during the WMA/

MP3/MPEG-4 AAC compression process,

sound quality often suffers from an uneven

sound image. The Sound Retriever feature

employs new DSP technology that helps bring

CD quality sound back to compressed 2-

channel audio by restoring sound pressure

and smoothing jagged artifacts left over after

compression.

• While listening to a stereo source, press

SOUND RETRIEVER to switch the sound

retriever on or off.

Enhancing dialogue

The Dialogue Enhancement feature is

designed to make the dialogue stand out from

other background sounds in a TV or movie

soundtrack.

1 Press

SOUND

and use

/

to select

DIALOGUE

then press

ENTER

.

2Use

/

to select the amount of

dialogue enhancement then press

ENTER

to

confirm.

Select between OFF, MID or MAX.

Using the Tone controls

You can change the tonal balance of the sound

by using the tone control menu.

1 Press

SOUND

and use

/

to select

TONE then press

ENTER

.

2Use

/

to select the option you want to

adjust and press

ENTER

.

The Bass/Treble, Quiet and Midnight features

cannot be used at the same time.

Adjusting the bass and treble

Use the tone controls to adjust the bass and

treble.

•Use

/

to select BASS or TREBLE then

use

/

to adjust the tone.

Press ENTER to

confirm

.

Quiet and Midnight modes

The Quiet listening feature reduces excessive

bass or treble in a sound source.

The Midnight listening feature allows you to

hear effective surround sound of movies at low

volume levels.

• After pressing

ENTER, the setting

switches on/off.

• To cancel the Quiet or Midnight listening

modes, select BASS/TRE.

Boosting the bass level

There are two bass modes you can use to

enhance the bass in a source.

1

1Press

SOUND

and use

/

to select

BASSMODE then press

ENTER

.

2Use

/

to adjust the sound

then press

ENTER to confirm

.

Select between OFF, MUSIC or CINEMA.

Note

1 The Bass Mode is not available when headphones are connected.

DCS-580_EN.book 17 ページ２００８年２月２９日　金曜日　午後８時４１分

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 53 54

Comments to this Manuals

No comments