Pioneer HTP-070 User Manual download pdf (Page 3)

English

Français

Italiano

Español

Nederlands

Deutsch

Connecting the speakers

Connecting a TV and playback component

Plugging the receiver

CAUTION

• These speaker terminals carry HAZARDOUS LIVE voltage. To prevent

the risk of electric shock when connecting or disconnecting the

speaker cables, disconnect the power cord before touching any

uninsulated parts.

• Make sure that all the bare speaker wire is twisted together and

inserted fully into the speaker terminal. If any of the bare speaker

wire touches the back panel it may cause the power to cut off as a

safety measure.

• Do not connect the supplied subwoofer to any amplifier other than

the one supplied with this system. Connection to any other amplifier

may result in malfunction or fire.

Make sure you connect the speaker on the right to the right (R) terminal and the speaker on the left to the left (L) terminal. Also make sure the positive and negative (+/–)

terminals on the receiver match those on the speakers.

Bare wire connections

Push open the tabs and insert exposed wire.

Release the tabs.

Placing the speakers

The receiver will work with just two stereo speakers (the

front speakers in the diagram) but using at least three

speakers is recommended, and a complete setup is

best for surround sound.

To achieve the best possible surround sound, install

your speakers as shown below.

5.1 channel surorund system:

• In addition, surround back speakers can also be

connected.

“Connect the surround back speakers”

• The subwoofer and surround speakers are not

magnetically shielded and so should not be placed

near a TV or monitor, as the interaction of magnetic

materials can cause distortion of the colors on your

TV screen. Devices easily affected by magnetism

(magnetic media cards, wrist-watches, video tapes,

etc.) should not be placed near the subwoofer and

surround speakers.

• The front speakers and center speaker furnished

in this system are designed for use close to a CRT-

based TV or color monitor. However, if color distortion

is caused due to the installation, try turning off the

power to the CRT-based TV or color monitor for 15

to 30 minutes, then turning on the power again. The

self-degaussing function built into the CRT-based TV

or color monitor should help ameliorate the effect

of the speakers on the image. If color distortion

continues to be a problem, separate the speakers

farther away from the screen. If magnets or devices

emitting magnetic fields are installed nearby, the

interactive effect with the speaker system may cause

color distortion in a CRT-based TV or color monitor.

• Do not attach center speaker and subwoofer to the

wall or ceiling, as they may cause injury in the event

of a fall.

Flow of settings on the receiver

VENTILATION CAUTION

When installing this unit, make sure to leave space around the unit for

ventilation to improve heat radiation (at least 20 cm at top, 10 cm at rear,

and 10 cm at each side).

WARNING

Slots and openings in the cabinet are provided for ventilation to ensure

reliable operation of the product, and to protect it from overheating. To

prevent fire hazard, the openings should never be blocked or covered

with items (such as newspapers, table-cloths, curtains) or by operating

the equipment on thick carpet or a bed.

D3-4-2-1-7b*_A1_En

COAXIAL

AUDIO

SPEAKERS

ANTENNA

OPTICAL

ASSIGNABLE

OUT

CD-R/TAPE

OUT

SURR BACK

PRE OUT

(

Single

)

(

CD-R / TAPE

)

IN CD/SAT

DVD

BD IN CD/SAT

(

)

UNBAL

AM LOOP

FRONT CENTER

SURROUND SUBWOOFER

RLRL

AC I

Front Right

Center

Front Left

Subwoofer

Surround

Right

Surround

Left

Be sure to complete

all connections before

connecting this unit to

the AC power source.

The unit is a full-fledged AV receiver equipped with an

abundance of functions and terminals. It can be used

easily after following the procedure below to make the

connections and settings.

Front left

(S-11-P)

Subwoofer

(S-22W-P)

Center

(S-11-P)

This receiver

(VSX-321-K-P)

Blu-ray Disc

player

Front right

(S-11-P)

Surround left

(S-11-P)

Surround right

(S-11-P)

CAUTION

• Install the center speaker below the TV so that the

sound of the center channel is localized at the TV

screen.

• When installing the center speaker on top of

the TV, be sure to secure it with tape or some

other suitable means. Otherwise, the speaker

may fall from the TV due to external shocks such

as earthquakes, endangering those nearby or

damaging the speaker.

1 2 3 4 5 6 7 8 ... 27 28

Comments to this Manuals

No comments

Pioneer HTP-070 User Manual Page 3

Comments to this Manuals

Related products and manuals for Home Theater Systems Pioneer HTP-070