Pioneer HTP-071 User Manual download pdf (Page 4)

Connecting a TV and playback component

Plugging the receiver

If you have an HDMI or DVI (with HDCP) equipped component (Blu-ray Disc player, etc.), you can connect it to this

receiver using a commercially available HDMI cable.

• The following connection/setting is required to listen to the sound of the TV over this receiver.

– If the TV does not support the HDMI Audio Return Channel function, connect the receiver and TV with audio

cables (as shown).

– If the TV supports the HDMI Audio Return Channel function, the sound of the TV is input to the receiver via the

HDMI terminal, so there is no need to connect an audio cable. In this case, set ARC at HDMI Setup to ON.

– The ARC function may not operate even with the above connections. If this is the case, connect the receiver

and the TV with an audio cable.

About video outputs connection

This receiver is not loaded with a video converter.

When you use HDMI cables for connecting to the

input device, the same cables should be used for

connecting to the TV.

The signals input from the analog (composite) video

input of this unit will not be output from the HDMI

OUT.

HDMI

VIDEO

COAXIAL

AUDIO

SPEAKERS

ANTENNA

OPTICAL

ASSIGNABLE

OUT

CD-R/TAPE

OUT

SURR BACK

PRE OUT

(

Single

)

(

CD-R / TAPE

)

IN CD/SAT

MONITOR

OUT

CD/SAT

DVD

DVR/BDR IN DVD IN BD IN CD/SAT

(

)

UNBAL

AM LOOP

FRONT CENTER

SURROUND SUBWOOFER

RLRL

HDMI INHDMI OUT DIGITAL AUDIO OUT

OPTICAL

HDMI/DVI-compatible components

(Blu-ray Disc player, etc.)

HDMI/DVI-compatible TV

If the TV does not support the

HDMI Audio Return Channel

function, this connection is

required to listen to the TV

sound over the receiver.

If the device you wish to

connect does not have an

HDMI output terminal, it

can be connected via these

terminals.

“

Connecting

your component with no HDMI

terminal”

CAUTION

• Handle the power cord by the plug part. Do not pull

out the plug by tugging the cord, and never touch the

power cord when your hands are wet, as this could

cause a short circuit or electric shock. Do not place

the unit, a piece of furniture, or other object on the

power cord or pinch the cord in any other way. Never

make a knot in the cord or tie it with other cables. The

power cords should be routed so that they are not

likely to be stepped on. A damaged power cord can

cause a fire or give you an electric shock. Check the

power cord once in a while. If you find it damaged,

ask your nearest Pioneer authorized independent

service company for a replacement.

• Do not use any power cord other than the one

supplied with this unit.

• Do not use the supplied power cord for any purpose

other than that described below.

• The receiver should be disconnected by removing the

mains plug from the wall socket when not in regular

use, e.g., when on vacation.

Connecting antennas

Connect FM wire antenna and the the AM loop antenna

as shown below.

ANTENNA

UNBAL

AM LOOP

Only plug in after you have connected all your components to this receiver, including the speakers.

Plug the supplied power cord into the AC IN socket on the back of the receiver.

Plug the other end into a power outlet.

AC IN

To power outlet

1 2 3 4 5 6 7 8 9 ... 31 32

Comments to this Manuals

No comments

Pioneer HTP-071 User Manual Page 4

Comments to this Manuals

Related products and manuals for Home Theater Systems Pioneer HTP-071