Pioneer DJM-600 User Manual Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
6
<DRB1251>
L
R
L
R
L
R
MASTER
OUT2
R
MASTER
LEVEL
ATT.
SIGNAL
GND
MASTER
OUT 1
PHONO 3 LINE
CH - 4
PHONO 2 LINE
CH - 3
PHONO 1 CD 2 /LINE LINE CD 1 /LINE
CH - 2 CH - 1
CH - 1CH - 2
PLAYER CONTROL
BOOTH
MONITOR
L
RR
RETURN CH - 4 SUBMICSENDREC OUT
LR
2 COLD
1 GND
3 HOT
L
(MONO)
L
(MONO)
L
R
L
R
110-120V220-230
-240V
VOLTAGE
SELECTOR
*1
R LR LR L R L
R LR LR L R L
Cassette deck, etc.
CONNECTIONS
When connecting or changing the connection of units, make sure to first turn off the power switch and disconnect the power cord
from the outlet.
1. Connection of Input Equipment
DAT, etc.
DAT, etc.
CD 2 CD 1
CDJ-100S/
CDJ-700S/
CDJ-500
II
CDJ-100S/
CDJ-700S/
CDJ-500 II
Control cord
*2
(Can be connected to the
CDJ-100S, CDJ-700S and
CDJ-500
II, etc.)
DJM-600
Connect to a wall’s
electrical outlet
Player 3
*3
Player 2
*3
Player 1
*3
(PHONO 3 cannot be used if
connecting a sub-microphone.)
If connecting an analog player, remove the six short-circuit
pin plugs inserted in the PHONO terminals (PHONO 1,
PHONO 2 and PHONO 3) of CH-2, CH-3, and CH-4.
These short-circuit pin plugs serve to cut fine noise, ensuring
outstanding performance when no analog player is
connected. Make sure to store the plugs carefully after
removing them. When you disconnect an analog player,
reinsert the plugs as they were originally.
*1 Connect the cord for the analog player’s ground.
This terminal is exclusively for an analog player and is not
a safety earth.
*2 If you are using the unit with the separately sold CDJ-
100S, CDJ-700S, or CDJ-500
II connected to the CH-1 or
CH-2 CD terminals, the fader start function can be used if
the unit and CD player are connected with a control cord.
*3 Because the unit’s PHONO input terminals are
exclusively for MM, use MM-type cartridges for the
analog player connected.
Connecting audio cords
Use the cords with the red and white pin plugs.
Connect the white plug to ”L“ and the red plug to ”R“. Make
sure to insert the plugs completely.
L
R
White plug
Red plug
Page view 5
1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Comments to this Manuals

No comments