Pioneer In-Wall Speaker S-IW651-LR User Manual download pdf (Page 4)

Painting the speakers

While the speaker and grille can be painted after it is

installed, painting it beforehand is much easier.

It is recommended to use spray paint, as brushed paint

may clog the holes in the grille and reduce the sound

quality significantly.

1 Remove the fabric scrim from the inside of the

grille.

Carefully peel off the fabric scrim and lay it down flat so

as not to get it wrinkled.

2 Use the supplied paint mask to cover the speaker.

If you don’t have the paint mask, use paper and masking

tape.

3 Paint the speaker and grille the desired color.

As previously mentioned, it is strongly recommended

that you paint before installation and that you use spray

paint.

4 After the speaker and grille have dried completely,

remove the paint mask and carefully replace the fabric

scrim on the back of the grille.

Before installing

• Before installing the speakers, run the speaker

cables to the installation location.

• To maximize sound quality, choose the correct

speaker gauge cables from the table below.

If the resistance of the speaker cable is too high, the

signal will be attenuated and the speakers’ frequency

response will be degraded.

How to install

Make sure you have read and understood all the

information above, For the installer on page 3 and Before

installing above.

1 Once you have decided on the installation location,

prepare the supplied template.

Cut out the inside of the template along the dotted line

and discard the inner section.

2 Attach the template (outer section) to the wall/

ceiling using tape.

Make sure the template is aligned properly.

3 Trace a line onto the wall/ceiling, following the

inner perimeter of the template.

4 Cut a hole where you have drawn the outline.

Be careful when cutting the hole, and use a proper

cutting tool.

5 Pull the speaker cable through the hole that has

been opened.

Be careful not to apply to much force when pulling on the

speaker cable or bend the cable at sharp angles.

6 Connect the cable wire to the speaker as shown

below.

When connecting the speakers, be careful not to touch

the diaphragms of the drivers.

AWG feet

meters

16 or 14 less than 25 1.5 to 2.5 less than 8

14 or 12 25 to 50 2.5 to 4 8 to 16

12 or 10 50 to 75 4 to 6 16 to 24

10 more than 75 6 more than 24

Twist and pull off the protective

shields on each wire.

10 mm (0.4 in.)

Insert the speaker cable wires into the

holes while pressing down on the terminal

posts on the speaker, and then release the

terminal posts. For input terminal polarity,

red is positive (+) and black is negative (–).

SRD1374A_IW631831651851.book 4 ページ２００８年８月８日　金曜日　午後２時４０分

1 2 3 4 5 ... 16

Comments to this Manuals

No comments

Pioneer In-Wall Speaker S-IW651-LR User Manual Page 4

Comments to this Manuals

Related products and manuals for Car speakers Pioneer In-Wall Speaker S-IW651-LR