Pioneer VSX-921 User Manual download pdf (Page 4)

Transferring measurement data from the receiver to the

computer

To display on the computer the various data measured on the receiver, use AVNavigator to transfer the data

from the receiver to the computer.

If MCACC Application is launched automatically after the “Full Auto MCACC” operation has been performed

with AVNavigator’s “Wiring Navi” and measurements have been taken, the measurement data has already

been transferred to the computer. To recheck the measurement data in this case, proceed to the next

section, Applications Operations

(page 6).

If “Wiring Navi” has not been performed and you want to transfer the data measured under an environment

different from that of “Wiring Navi” to the computer, use the procedure described below.

1 Perform the “Full Auto MCACC” operation on the receiver. (See the receiver’s

Operating Instructions.)

2 After the “Full Auto MCACC” operation is completed, press the “HOME MENU”

button to close the home menu.

The measurement data is prepared to be sent at the point that the home menu is closed.

3 Launch AVNavigator on the computer.

From the AVNavigator menu, select “Settings”, then select the “MCACC Data” tab.

5 Specify the “MCACC Data Storage Folder”.

The measurement is saved in the folder specified here. The folder in which the data is saved can be

changed by pressing “Change”.

From the AVNavigator menu, select “MCACC Appli” to launch MCACC Application.

When the MCACC application is launched, the “MCACC data” screen appears simultaneously.

7 Follow the instructions on the “MCACC data” screen to download the data

measured in step 1.

The data measured in step 1 is transferred to the folder specified in step 4.

Proceed to Applications Operations

(page 6) and call out the measurement data from the computer.

Continue

1 2 3 4 5 6 7 8 9 ... 26 27

No comments

Pioneer VSX-921 User Manual Page 4