Pioneer VSX-452 User Manual Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 24
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
t BEFORE OPERATING, ADJUST THE POSITION OF THESE SWITCHES
]
TWO VOLTAGE SELECTOR SWITCHES I
Only multi-voitage models are provided with these switches. U.S.,
Canadian, European, U.K. and Australian models are not provided with
these switches.
Mains voltages in Saudi Arabia are 127 V and 220 V only. Never use
this model with 110 V setting in Ssudi Arabia.
The line voltage selector switches are on the rear panel. Before your
model is shipped from the factory, these switches are set to the power
requirements of the destination. Check that they are set properlybefore
plugging the power cord into the household wall socket. If the voltage
is not properly set or if you move to an area where the voltage
requirements differ, adjust the selector switches as follows.
1. Use a medium-size screwdriver.
2. First, insert a screwdriver in the groove of the voltage selector at
the right, and adjust sothat the tipof the groove pointsto the voltage
value of your area.
3. Next, insert a screwdriver in the groove of the voltage selector at
the left and adjust until the voltage is the same as at the right.
CHANNEL STEP SWITCH I
(Not available on U.S. and Canadian models)
I
The unit has been factory preset to the channel allocation for the area
inwhich it is to besold. If these values are set incorrectly, the frequency
display may stop at the wrong frequency, resulting in an inability to
reproducereceptionsignalsat their propersound quality. Forthis reason,
be sure to confirm that the values are set correctly before first using
the unit.
[100 kHzll0 kHz] position:
Set to this position for areas with an FM reception step of 1O0 kHz,
AM 10 kHz.
[50 kHz/9 kHz] position:
Set to this position, for areas with an FM reception step of 50 kHz,
AM 9 kHz.
NOTE."
When unsure about the channel allocation for your area, consult your
dealer for correct information.
TWO VOLTAGE
SELECTORS
t,t0-1Z71f
asoV
Z4OV V
t10V 1J_0-117V
J
CAUTION: TWO VOLTAGE SELECTORS
AC 220V AC 240V'-
AC 120
AC 110V -127V
1 lOV 120 -127V 220V 240V
llOV
120V-127V
rD
220v
Z40V
NOTE..
Bothswitches must be in the same switch
setling; otherwise, unit can be damaged.
l CHAN[__L STEP
::I[::::j
ACCESSORY ITEMS
Power cord FM Antenna
Remote control unit
Dry cell batteries
(size "AAA" (RO3/UM-4))
D
AM Loop Antenna
Precaution regarding Installation position of cassette deck.
If the cassette tape deck is installed in the (_ positions shown in
the drawing below, it may be adversely affected during playback.
If possible, it's better to install it in the _) position.
®
Receiver
v
®
®
4
<ARB1424>
Page view 3
1 2 3 4 5 6 7 8 9 ... 23 24

Comments to this Manuals

No comments