Pioneer AVH-P5700DVD User Manual Page 13

  • Download
  • Add to my manuals
  • Print
  • Page
    / 86
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 12
English
Español
Deutsch
Français
Italiano
Nederlands
<CRD3965-A> 13
12
ENG/MASTER 96 INST
Installation
Note:
Before making a final installation of the unit, tem-
porarily connect the wiring to comfirm that the
connections are correct and the system works
properly.
Use only the parts included with the unit to ensure
proper installation. The use of unauthorized parts
can cause malfunctions.
Consult with your nearest dealer if installation
requires the drilling of holes or other modifica-
tions of the vehicle.
Install the unit where it does not get in the dri-
vers way and cannot injure the passenger if there
is a sudden stop, like an emergency stop.
Do not install the display where it may (i) obstruct
the driver's vision, (ii) impair the performance of
any of the vehicle's operating systems or safety
features, including air bags, hazard lamp buttons
or (iii) impair the driver's ability to safely operate
the vehicle.
The semiconductor laser will be damaged if it
overheats, so dont install the unit anywhere hot
for instance, near a heater outlet.
If installation angle exceeds 30° from horizontal,
the unit might not give its optimum performance.
(Fig. 12)
Fig. 12
The cords must not cover up the area shown in the
figure below. This is necessary to allow the
amplifires to radiate freely. (Fig. 13)
Fig. 13
DIN Front/Rear-mount
This unit can be properly installed
either from Front (conventional DIN
Front-mount) or Rear (DIN Rear-
mount installation, utilizing threaded
screw holes at the sides of unit chas-
sis). For details, refer to the following
illustrated installation methods.
Before installing the unit
Remove the frame and the hold-
er. (Fig. 14)
Pull out to remove the frame and then
loosen the screws (2 × 3 mm) to
remove the holder. (When reattaching
the frame, point the side with a groove
downwards and attach it.)
Fig. 14
Holder
Frame
Screw (2 × 3 mm)
Do not close this area.
30°
Page view 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 85 86

Comments to this Manuals

No comments