Pioneer SC-25 Operations Instructions download pdf (Page 103)

Controlling the rest of your system (In case of SC-25)

103

Controlling the rest of your system

(In case of SC-25)

Important

• This section includes explanations for the SC-25’s

remote control. For instructions for the SC-27’s

remote control, see Controlling the rest of your

system (In case of SC-27) on page 96.

Operating multiple receivers

The remote control included with this receiver can be

used to operate up to three other receivers (of the same

model as this receiver) in addition to this receiver. The

receiver to be operated is switched by inputting the

preset code to set the remote control setting.

• Set the remote modes on the receivers before using

this function (see Remote Control Mode Setup on

page 130).

1 Check the operation selector switch to

MAIN

2Press .

3 Press and hold

REMOTE SETUP

, then release it after

the LED flashes twice.

4 Use the number buttons to enter the 5-digit preset

code (see below).

• Receiver 1: 6 1 9 3 5 (Default)

• Receiver 2: 6 2 6 3 0

• Receiver 3: 6 2 6 3 1

• Receiver 4: 6 2 6 3 2

When the preset code is fully input, the LED flashes once

to indicate that the setting is completed.

To operate another receiver, start over from step 1 to

input its preset code.

Setting the remote to control other

components

Most components can be assigned to one of the input

function buttons (such as DVD or CD) using the

component’s manufacturer preset code stored in the

remote.

However, there are cases where only certain functions

may be controllable after assigning the proper preset

code, or the codes for the manufacturer in the remote

control will not work for the model that you are using.

If you can’t find a preset code that matches the

component you want to control, you can still teach the

remote individual commands from another remote

control (see Programming signals from other remote

controls on page 104).

Note

• You can cancel or exit any of the steps by pressing

. To go back a step, press RETURN.

• After ten seconds of inactivity, the remote

automatically exits the operation.

Selecting preset codes directly

1 Press the input function button for the component

you want to control.

When assigning preset codes to TV CONTROL, press TV

CTRL here.

2 Press and hold

REMOTE SETUP

, then release it after

the LED flashes twice.

3 Use the number buttons to enter the 5-digit preset

code.

See Preset code list on the separate booklet.

The LED flashes twice when the preset code has been

properly registered. When the preset code is fully input,

the LED flashes once to indicate that the setting has

failed.

INPUT

123

HDMI OUT

SLEEPMCACC

INPUT

SELECT

SIGNAL SEL

456

DIMMERA.ATTSBch

789

CLASS

MASTER

VOLUME

CH LEVELD.ACCESS

/CLR

ENTER

456

789

REMOTE

SETUP

ZONE 2

MAIN

ZONE 3

AUDIO

MULTI OPE

INFO

DISP

RECEIVER

TV CTRL

RECEIVER

REMOTE

SETUP

MAIN

RECEIVER

Note

1 You can’t assign , TUNER, HOME MEDIA GALLERY, iPod USB, XM or SIRIUS.

RECEIVER

SC-27_25.book Page 103 Monday, April 6, 2009 7:15 PM

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 153 154

Comments to this Manuals

No comments

Pioneer SC-25 Operations Instructions Page 103

Comments to this Manuals

Related products and manuals for AV receivers Pioneer SC-25