Pioneer VSX-39TX User Manual download pdf (Page 51)

OPERATION

Basic Playback

Adjusting Bass and Treble (Tone Control)

You can use BASS +/– or TREBLE +/– buttons to adjust the low and high frequencies for each individual set of

speakers. If the receiver is in STEREO mode you can only adjust the FRONT speakers. In a surround mode

(STANDARD, ADVANCED THEATER, etc.) you can adjust the FRONT, CENTER, SURROUND and SURROUND

BACK speakers. The TONE button can also be used to bypass the tone circuitry (See p.22).

memo

Listening in LOUDNESS Mode

The LOUDNESS mode allows you to boost the bass in a signal. It is useful for listening to music at low volumes.

Press the LOUDNESS button on the

remote control’s Receiver MAIN

screen or on the front panel.

Each press switches LOUDNESS mode on or off.

STEREO

LOUDNESSSIGNAL

SELECT

ANALOG

AUTO

VOLUME

• You can’t use the LOUDNESS mode with the

MULTI CH IN or THX modes.

• If you press LOUDNESS in DIRECT mode the

receiver will switch to STEREO mode.

Receiver

MAIN SUB

DSP STEREO

THX

ADVANCED

THEATER

EFFECT

STANDARD

MIDNIGHT

LOUDNESS

MULTI CH

SIGNAL

SELECT

DIGITAL

/ dts

LOUDNESS

• The tone control can be adjusted in a range of

±6 dB.

• The tone control cannot be adjusted in THX,

MULTI CH IN.

• If the receiver is in DIRECT mode and you press

the TONE button, TONE BYPASS will appear in

the display, letting you know that you can't

change the tone in DIRECT mode. Another

press cancels DIRECT mode.

LOUDNESS

SELECT

TONE

SPEAKER

A/B

Receiver

MAIN SUB

TREBLE

SYSTEM

SETUP

LEVEL

INPUT

ATT.

BASS

DIMMER

TAPE 2

MONITOR

TREBLE

BASS

CHANNEL SELECT

TONE

Press the TONE button on the

remote control's Receiver SUB

screen or front panel to put the

receiver in tone adjust mode.

TONE: ON should appear in the display. If TONE:

BYPASS appears, press the button again to get

TONE:ON the tone adjust mode.

Press the CH SELECT button on the

remote control or CHANNEL

SELECT button on the front panel to

cycle through the different tone

adjust channels.

The button cycles though the possibilities in the

following order:

TONE Front TONE Center

TONE SurBack TONE Surr.

Use the BASS or TREBLE (+/–)

buttons to adjust the low or high

frequencies of each channel.

Display when using the TONE +/- buttons.

STEREO

SIGNAL

SELECT

ANALOG

VOLUME

A few seconds after you finish adjusting the tone the

receiver will revert to the sound mode it was in at the

beginning of the process.

memo

MAIN

SUB

1 ... 50 51 52 ... 92

Comments to this Manuals

No comments

Pioneer VSX-39TX User Manual Page 51

Comments to this Manuals

Related products and manuals for AV receivers Pioneer VSX-39TX