Pioneer HD3 Installation Guide Page 10

  • Download
  • Add to my manuals
  • Print
  • Page
    / 58
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 9
9
Connecting the System
ENG/MASTER 96
<CRD4324A/U> 10
Connecting the power cord (1)
Connect leads of the same
colour to each other.
Cap (*1)
When not using this terminal,
do not remove the cap.
ISO connector
Fuse (10 A)
*1
*2
*4
*3
*5
Yellow (*2)
To terminal always supplied
with power regardless of
ignition switch position.
Red (*4)
To electric terminal controlled
by ignition switch (12 V DC)
ON/OFF.
Yellow (*3)
Back-up
(or accessory)
Red (*5)
Accessory
(or back-up)
Black (earth)
To vehicle (metal) body.
Orange/white
To lighting switch terminal.
Note:
In some vehicles, the ISO connector
may be divided into two. In this case,
be sure to connect to both connectors.
Note:
Depending on the kind of vehicle, the
function of *3 and *5 may be different.
In this case, be sure to connect *2 to *5
and *4 to *3.
Speaker leads
White: Front left +
White/black: Front left
Grey: Front right +
Grey/black: Front right
Green: Rear left + or Subwoofer + (*9)
Green/black: Rear left or Subwoofer (*9)
Violet: Rear right + or Subwoofer + (*9)
Violet/black: Rear right or Subwoofer (*9)
Yellow/black
If the vehicle can send a mute signal to this terminal,
the mute function can be activated on this navigation
system when the terminal is connected to *8.
Note:
When a subwoofer (*9) is connected to this naviga-
tion system instead of a rear speaker, change the
rear output setting in the Initial Setting. (Refer to
the operation manual.) The subwoofer output of this
navigation system is monaural.
When using a subwoofer of 70 W (2 ), be sure to
connect with violet and violet/black leads of this
navigation unit. Do not connect anything with green
and green/black leads.
02_CRD4324-A_inst_001_029_UK 08.1.28 2:56 PM Page 10
<CRD4324-A> 10
Page view 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 57 58

Comments to this Manuals

No comments