Pioneer HD3 Installation Guide download pdf (Page 29)

After Installing this Navigation System

1. Reconnecting the battery.

First, double-check that all connections are correct and that this navigation system is

installed correctly. Reassemble all vehicle components that you previously removed. Then

reconnect the negative (–) cable to the negative (–) terminal of the battery.

2. Start the engine.

3. Press the RESET button on the navigation unit.

Press the RESET button on the navigation system using a pointed object such as the tip of

a pen.

4. Enter the following settings:

1. Make any necessary installation angle adjustments. (Refer to “Correcting the installation

angle” in “Chapter 10” of the operation manual.)

2. Change “Regional Settings” if necessary. (Refer to “Customising the Regional Settings”

in “Chapter 10” of the operation manual.)

3. Drive until the initialised sensors start operating normally.

Set the navigation system as explained in the operation manual or hardware manual.

After installing this navigation system, be sure to check at a safe place that the vehi-

cle is performing normally.

ENG/MASTER 96

English

Español

Deutsch

Français

Italiano

Nederlands

<CRD4324A/U> 29

02_CRD4324-A_inst_001_029_UK 08.1.28 2:56 PM Page 29

<CRD4324-A> 29

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 57 58

No comments

Pioneer HD3 Installation Guide Page 29