Pioneer DEH-P510UB User Manual download pdf (Page 29)

1 Use MULTI-CONTROL to select Clock in

the initial setting menu.

Refer to Adjusting initial settings on the pre-

vious page.

2 Push MULTI-CONTROL left or right to

select the segment of the clock display you

wish to set.

Pushing MULTI-CONTROL left or right will se-

lect one segment of the clock display:

Hour—Minute

As you select segments of the clock display,

the selected segment blinks.

3 Push MULTI-CONTROL up or down to

put a clock right.

Note

You can match the clock to a time signal by

pressing MULTI-CONTROL.

! If 00 to 29, the minutes are rounded down.

(e.g., 10:18 becomes 10:00.)

! If 30 to 59, the minutes are rounded up. (e.g.,

10:36 becomes 11:00.)

Switching the warning tone

If the front panel is not detached from the

head unit within four seconds of turning off

the ignition, a warning tone sounds. You can

turn off the warning tone.

1 Use MULTI-CONTROL to select

Warning tone in the initial setting menu.

Refer to Adjusting initial settings on the pre-

vious page.

2 Press MULTI-CONTROL to turn warning

tone on.

# To turn warning tone off, press

MULTI-CONTROL again.

Switching the auxiliary setting

Auxiliary devices connected to this unit can be

activated individually. Set each AUX source to

ON when using. For more information about

connecting or using auxiliary devices, refer to

Using the AUX source on page 33.

1 Use MULTI-CONTROL to select AUX1/

AUX2 in the initial setting menu.

Refer to Adjusting initial settings on the pre-

vious page.

2 Press MULTI-CONTROL to turn AUX1/

AUX2 on.

# To turn AUX off, press MULTI-CONTROL

again.

Switching the dimmer setting

To prevent the display from being too bright at

night, the display is automatically dimmed

when the car’s headlights are turned on. You

can turn the dimmer on or off.

1 Use MULTI-CONTROL to select Dimmer

in the initial setting menu.

Refer to Adjusting initial settings on the pre-

vious page.

2 Press MULTI-CONTROL to turn dimmer

on.

# To turn dimmer off, press MULTI-CONTROL

again.

Adjusting the brightness

You can adjust the display brightness.

1 Use MULTI-CONTROL to select

Brightness in the initial setting menu.

Refer to Adjusting initial settings on the pre-

vious page.

2 Push MULTI-CONTROL left or right to

adjust the brightness level.

0 to 15 is displayed as the level is increased or

decreased.

# When dimmer is functioning, the brightness

level can be adjusted 0 to 10.

Initial Settings

En

29

English

Section

04

1 ... 28 29 30 ... 218

Comments to this Manuals

No comments