Pioneer CDJ-800 MK2 User Manual download pdf (Page 2)

En <DRB1400>

The exclamation point within an equilateral

triangle is intended to alert the user to the

presence of important operating and

maintenance (servicing) instructions in the

literature accompanying the appliance.

The lightning flash with arrowhead symbol,

within an equilateral triangle, is intended to

alert the user to the presence of uninsulated

"dangerous voltage" within the product's

enclosure that may be of sufficient

magnitude to constitute a risk of electric

shock to persons.

CAUTION:

TO PREVENT THE RISK OF ELECTRIC

SHOCK, DO NOT REMOVE COVER (OR

BACK). NO USER-SERVICEABLE PARTS

INSIDE. REFER SERVICING TO QUALIFIED

SERVICE PERSONNEL.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

IMPORTANT

D3-4-2-1-1_En-A

Do not connect either wire to the earth terminal of a

three pin plug.

NOTE

After replacing or changing a fuse, the fuse cover in

the plug must be replaced with a fuse cover which

corresponds to the colour of the insert in the base

of the plug or the word that is embossed on the

base of the plug, and the appliance must not be

used without a fuse cover. If lost replacement fuse

covers can be obtained from your dealer.

Only 5 A fuses approved by B.S.I or A.S.T.A to

B.S.1362 should be used.

D3-4-2-1-2-2_En

The wires in this mains lead are coloured in

accordance with the following code:

Blue : Neutral

Brown : Live

If the plug provided is unsuitable for your socket

outlets, the plug must be cut off and a suitable plug

fitted.

IMPORTANT

FOR USE IN THE UNITED

KINGDOM

The cut-off plug should be disposed of and must

not be inserted into any 13 amp socket as this can

result in electric shock. The plug or adaptor or the

distribution panel should be provided with 5 A fuse.

As the colours of the wires in the mains lead of this

appliance may not correspond with coloured

markings identifying the terminals in your plug,

proceed as follows ;

The wire which is coloured blue must be connected

to the terminal which is marked with the letter N or

coloured black.

The wire which is coloured brown must be

connected to the terminal which is marked with the

letter L or coloured red.

Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified

service personnel.

CAUTION

This product is a class 1 laser product, but this

product contains a laser diode higher than Class 1.

To ensure continued safety, do not remove any covers

or attempt to gain access to the inside of the product.

Refer all servicing to qualified personnel.

The following caution label appears on your unit.

Location: top of the CD drive

CLASS 1

LASER PRODUCT

D3-4-2-1-8_B_En

CAUTION

ATTENTION

CLASS 3B INVISIBLE LASER RADIATION

WHEN OPEN, AVOID EXPOSURE TO BEAM.

RADIATIONS LASER INVISIBLES DE CLASSE 3B QUAND

OUVERT. ÉVITEZ TOUT EXPOSITION AU FAISCEAU.

ADVARSEL

KLASSE 3B USYNLIG LASERSTRÅLING VED ÅBNING.

UNDGÅ UDSÆTTELSE FOR STRÅLING.

VARNING

KLASS 3B OSYNLIG LASERSTRÅLNING NÄR DENNA DEL

ÄR ÖPPNAD. UNDVIK ATT UTSÄTTA DIG FÖR STRÅLEN.

VARO!

AVATTAESSA OLET ALTTIINA NÄKYMÄTTÖMÄLLE

LUOKAN 3B LASERSÄTEILYLLE. ÄLÄ KATSO SÄTEESEEN.

PRECAUCIAÓN

CUANDO SE ABRE HAY RADIACIÓN LÁSER DE CLASE 3B

INVISIBLE. EVITE LA EXPOSICIÓN A LOS RAYOS LÁSER.

VORSICHT

BEI GEÖFFNETER ABDECKUNG IST UNSICHTBARE LASERSTRAHLUNG

DER KLASSE 3B IM GERÄTEINNEREN VORHANDEN. NICHT DEM

LASERSTRAHLAUSSETZEN!

DRW2308-A

WARNING

This equipment is not waterproof. To prevent a fire

or shock hazard, do not place any container filed

with liquid near this equipment (such as a vase or

flower pot) or expose it to dripping, splashing, rain

or moisture.

D3-4-2-1-3_A_En

WARNING

The voltage of the available power supply differs

according to country or region. Be sure that the

power supply voltage of the area where this unit

will be used meets the required voltage (e.g., 230V

or 120V) written on the rear panel.

D3-4-2-1-4_A_En

Before plugging in for the first time, read the following

section carefully.

WARNING

To prevent a fire hazard, do not place any naked

flame sources (such as a lighted candle) on the

equipment.

D3-4-2-1-7a_A_En

VENTILATION CAUTION

When installing this unit, make sure to leave space

around the unit for ventilation to improve heat

radiation (at least 5 cm at rear, and 5 cm at each

side).

WARNING

Slots and openings in the cabinet are provided for

ventilation to ensure reliable operation of the

product, and to protect it from overheating. To

prevent fire hazard, the openings should never be

blocked or covered with items (such as newspapers,

table-cloths, curtains) or by operating the

equipment on thick carpet or a bed.

D3-4-2-1-7b_A_En

Operating Environment

Operating environment temperature and humidity:

+5 ºC – +35 ºC (+41 ºF – +95 ºF); less than 85 %RH

(cooling vents not blocked)

Do not install this unit in a poorly ventilated area, or in

locations exposed to high humidity or direct sunlight (or

strong artificial light)

D3-4-2-1-7c_A_En

This product complies with the Low Voltage Directive

(73/23/EEC, amended by 93/68/EEC), EMC Directives

(89/336/EEC, amended by 92/31/EEC and

93/68/EEC).

D3-4-2-1-9a_En

If the AC plug of this unit does not match the AC

outlet you want to use, the plug must be removed

and appropriate one fitted. Replacement and

mounting of an AC plug on the power supply cord of

this unit should be performed only by qualified

service personnel. If connected to an AC outlet, the

cut-off plug can cause severe electrical shock. Make

sure it is properly disposed of after removal.

The equipment should be disconnected by removing

the mains plug from the wall socket when left

unused for a long period of time (for example, when

on vacation).

D3-4-2-2-1a_A_En

CAUTION

The POWER switch on this unit will not completely

shut off all power from the AC outlet. Since the

power cord serves as the main disconnect device for

the unit, you will need to unplug it from the AC outlet

to shut down all power. Therefore, make sure the

unit has been installed so that the power cord can

be easily unplugged from the AC outlet in case of an

accident. To avoid fire hazard, the power cord should

also be unplugged from the AC outlet when left

unused for a long period of time (for example, when

on vacation).

D3-4-2-2-2a_A_En

POWER-CORD CAUTION

Handle the power cord by the plug. Do not pull out the

plug by tugging the cord and never touch the power

cord when your hands are wet as this could cause a

short circuit or electric shock. Do not place the unit, a

piece of furniture, etc., on the power cord, or pinch the

cord. Never make a knot in the cord or tie it with other

cords. The power cords should be routed such that they

are not likely to be stepped on. A damaged power cord

can cause a fire or give you an electrical shock. Check

the power cord once in a while. When you find it

damaged, ask your nearest PIONEER authorized

service center or your dealer for a replacement.

S002_En

If you want to dispose this product, do not mix it with general

household waste. There is a separate collection system for used

electronic products in accordance with legislation that requires

proper treatment, recovery and recycling.

Private households in the 25 member states of the EU, in Switzerland and

Norway may return their used electronic products free of charge to desig-

nated collection facilities or to a retailer (if you purchase a similar new one).

For countries not mentioned above, please contact your local authorities for

the correct method of disposal.

By doing so you will ensure that your disposed product undergoes the neces-

sary treatment, recovery and recycling and thus prevent potential negative

effects on the environment and human health.

Thank you for buying this Pioneer product.

Please read through these operating instructions so you will know how to operate your model properly. After you have finished reading

the instructions, put them away in a safe place for future reference.

In some countries or regions, the shape of the power plug and power outlet may sometimes differ from that shown in the explanatory

drawings. However the method of connecting and operating the unit is the same.

K015 En

1 2 3 ... 116

Comments to this Manuals

No comments

Pioneer CDJ-800 MK2 User Manual Page 2

Comments to this Manuals

Related products and manuals for Musical Instruments Pioneer CDJ-800 MK2