Pioneer PDP-503HDE User Manual download pdf (Page 66)

HOWTO SET THE FACTORY PRESETTINGS

Press and hold down CLEAR on the Media Receiver while it is in standby mode. Then press STANDBY/ON

on the Plasma Display or 0 - 9 on the remote control unit to turn the Plasma Display System on.

All setting items (except TV channel) return to the factory presetting.

I NOTE >

• Running the factory presetting operation also clears the password.

You can run the Auto Installation again by using the following steps.

1 Turn on the power of the Plasma Display and the Media Receiver.

2 Press MENU. (Make sure the menu screen displays.)

3 Press T to select “Setup”.

4 Press ENTER.

I NOTE >

• If the passwor(d setting screen (displays, you need to enter your password.

• If you forget your password, refer to HOW TO SET THE EACTORY PRESETTINGS above.

5 Press A/V to select “Auto Installation”.

6 Press ENTER.

“Auto Installation completed” displays. After that, the screen changes to the TV mode.

The password is

I NOTE >

• As a precautionary measure, make a note of your password above, scissor it from this manual, and keep it in a familiar

place.

*1 SRS and the C#T symbol are trademarks of SRS Labs, Inc.

SRS technology is incorporated under license from SRS Labs, inc.

FOCUS and the C#T symbol are trademarks of SRS Labs, Inc.

FOCUS technology is incorporated under license from SRS Labs, Inc.

NOTE >

• Products above are a trademark or registered trademark of corporation.

(ID-63

1 ... 65 66 67 ... 196

No comments

Pioneer PDP-503HDE User Manual Page 66