Pioneer AVIC X1 Installation Guide download pdf (Page 6)

Connecting the System

Before installing the unit

• This unit is for vehicles with a 12-volt battery and negative earthing. Check the battery

voltage of your vehicle before installation.

To prevent damage

• When disconnecting a connector, pull the connector itself. Do not pull the lead, as you

may pull it out of the connector.

• This unit cannot be installed in a vehicle that does not have an ACC (accessory) position

on the ignition switch.

• To avoid short-circuiting, cover the disconnected lead with insulating tape. It is especial-

ly important to insulate all unused speaker leads, which if left uncovered may cause a

short circuit.

• Attach the connectors of the same colour to the corresponding coloured port, i.e., blue

connector to the blue port, black to black, etc.

• The black lead is earth. Please earth this lead separately from the earth of high-current

products such as power amps.

Do not earth more than one product together with the earth from another product. For

example, you must separately earth any amplifier unit away from the earth of the Hide-

away unit. Connecting earths together can cause a fire and/or damage the products if

their earths became detached.

• Refer to the owner’s manual for details on connecting the power amp and other units,

then make connections accordingly.

• When replacing the fuse, be sure to use only a fuse of the rating prescribed on the fuse

holder.

• Since a unique BPTL circuit is employed, do not directly earth the ≠ side of the speaker

lead or connect the ≠ sides of the speaker leads together. Be sure to connect the ≠ side

of the speaker lead to the ≠ side of the speaker lead on the display unit.

• If the RCA pin jack on the unit will not be used, do not remove the caps attached to the

end of the connector.

• When the auto aerial function is used by connecting the blue lead to the vehicle

with the auto aerial function, either turning off the ignition switch or detaching

the front panel will retract the auto aerial of the vehicle.

No ACC positionACC position

• To avoid shorts in the electrical sys-

tem, be sure to disconnect the (–)

battery cable before beginning

installation.

ENG/MASTER 96

CRD3836A_inst_001_031_UK 1/31/04 12:29 AM Page 6

1 2 3 4 5 6 7 8 9 10 11 ... 180 181

No comments

Pioneer AVIC X1 Installation Guide Page 6