Pioneer VSX-924 User Manual download pdf (Page 112)

112

Additional information

About messages displayed when using network functions

Refer to the following information when you come up with a status message while operating the Network

functions.

Status messages Descriptions

Connection Down

The selected category or Internet radio station cannot be accessed.

File Format Error

Cannot be played back for some reasons.

Track Not Found

The selected song has not been found anywhere on the network.

Server Error

The selected server cannot be accessed.

Server Disconnected

The server has been disconnected.

Empty

There are no files stored in the selected folder.

License Error

The license for the contents to be played back is invalid.

Item Already Exists

This is displayed when the file you have attempted to register in the Favorites folder has

already been registered.

Favorite List Full

This is displayed when you have attempted to register a file in the Favorites folder but the

Favorites folder is already full.

Important information regarding the HDMI connection

There are cases where you may not be able to route HDMI signals through this receiver (this depends on

the HDMI-equipped component you are connecting-check with the manufacturer for HDMI compatibility

information).

If you aren’t receiving HDMI signals properly through this receiver (from your component), please try one of the

following configurations when connecting up.

Configuration A

Use component video cables to connect the video output of your HDMI-equipped component to the receiver’s

component video input. The receiver can then convert the analog component video signal to a digital HDMI sig-

nal for transmission to the display. For this configuration, use the most convenient connection (digital is recom-

mended) for sending audio to the receiver. See the operating instructions for more on audio connections.

Note

The picture quality will change slightly during conversion.

Configuration B

Connect your HDMI-equipped component directly to the display using an HDMI cable. Then use the most conve-

nient connection (digital is recommended) for sending audio to the receiver. See the operating instructions for

more on audio connections. Set the display volume to minimum when using this configuration.

Notes

! If your display only has one HDMI terminal, you can only receive HDMI video from the connected component.

! Depending on the component, audio output may be limited to the number of channels available from the

connected display unit (for example audio output is reduced to 2 channels for a monitor with stereo audio

limitations).

! If you want to switch the input function, you’ll have to switch functions on both the receiver and your display

unit.

! Since the sound is muted on the display when using the HDMI connection, you must adjust the volume on the

display every time you switch input functions.

Cleaning the unit

! Use a polishing cloth or dry cloth to wipe off dust and dirt.

! When the surface is dirty, wipe with a soft cloth dipped in some neutral cleanser diluted five or six times with

water, and wrung out well, and then wipe again with a dry cloth. Do not use furniture wax or cleansers.

! Never use thinners, benzene, insecticide sprays or other chemicals on or near this unit, since these will cor-

rode the surface.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 122 123

Comments to this Manuals

No comments

Pioneer VSX-924 User Manual Page 112

Comments to this Manuals

Related products and manuals for AV receivers Pioneer VSX-924