Pioneer DVH-P590MP User Manual download pdf (Page 16)

Non-RDS or MW/LW











1 Band indicator

2 Preset number indicator

3 Frequency indicator

4 Stereo (5) indicator

Shows when the selected frequency is being

broadcast in stereo.

1 Press SOURCE to select the tuner.

2 Press BAND to select a band.

Press BAND until the desired band is dis-

played, FM1, FM2, FM3 for FM or MW/LW.

3 To perform manual tuning, briefly press

c or d.

4 To perform seek tuning, press and hold

c or d for about one second and release.

The tuner will scan the frequencies until a

broadcast strong enough for good reception is

found.

# You can cancel seek tuning by briefly pressing

c or d.

# If you press and hold c or d you can skip sta-

tions. Seek tuning starts as soon as you release

the button.

Storing and recalling broadcast

frequencies

If you press any of the preset tuning buttons 1

to 6 you can easily store up to six broadcast

frequencies for later recall with the touch of a

button.

! Up to 18 FM stations, six for each of the

three FM bands, and six MW/LW stations

can be stored in memory.

% When you find a frequency that you

want to store in memory, press one of pre-

set tuning buttons 1 to 6 and hold until the

preset number stops flashing.

The number you have pressed will flash in the

preset number indicator and then remain lit.

The selected radio station frequency has been

stored in memory.

The next time you press the same preset tun-

ing button the radio station frequency is re-

called from memory.

# You can also use a and b to recall radio sta-

tion frequencies assigned to preset tuning but-

tons 1 to 6.

Introduction of advanced

operations







1 Function display

Shows the function status.

2 LOC indicator

Shows when local seek tuning is on.

% Press FUNCTION repeatedly to switch

between the following functions:

BSM (best stations memory)—REG (regional)

—LOCAL (local seek tuning)—TA (traffic an-

nouncement standby)— AF (alternative fre-

quencies search)

# If MW/LW band is selected, you can only se-

lect BSM or LOCAL.

# To return to the frequency display, press

BAND.

# If you do not operate functions within about

30 seconds, the display is automatically returned

to the ordinary display.

Operating this unit

En

16

Section

03

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 96 97

Comments to this Manuals

No comments