Pioneer DVH-P590MP User Manual download pdf (Page 73)

Operating the DSP details menu







1 DSP display

Shows the DSP status.

2 PL II indicator

Shows when the Dolby Pro Logic II is turned

on.

% Press AUDIO and hold until AT EQ ap-

pears in the display, then press AUDIO to

display the DSP function names.

After AT EQ is displayed, press AUDIO repeat-

edly, the following DSP functions appear in

the display:

AT EQ (auto-equalizer on/off)—FRONT (speak-

er setting)—HPF (cross-over frequency)—

FRT-L (speaker output level)—TEST TONE (test

tone)—TA (time alignment mode)—FL (time

alignment adjustment)—PEQ-2 (3-band para-

metric equalizer)

# You can also use A.MENU button on the re-

mote control to select an audio menu.

# When you select TA OFF in TA INITIAL, you

cannot select FL.

# You cannot select AT EQ if auto TA and EQ

has not been carried out.

# To return to the display of each source, press

BAND.

Using the auto-equalizer

The auto-equalizer is the equalizer curve cre-

ated by auto TA and EQ (refer to Auto TA and

EQ (auto-time alignment and auto-equalizing)

on this page).

You can turn the auto-equalizer on or off.

1 Press AUDIO and hold until AT EQ ap-

pears in the display.

# If auto TA and EQ have not been carried out,

SET A.EQ is displayed when AT EQ is selected.

2 Press a to turn the auto-equalizer on.

AT EQ ON appears in the display.

# To turn auto-equalizer off, press b.

Auto TA and EQ (auto-time

alignment and auto-equalizing)

The auto-time alignment is automatically ad-

justed for the distance between each speaker

and the listening position.

The auto-equalizer automatically measures

the car interior acoustic characteristics, and

then creates the auto-equalizer curve based

on that information.

WARNING

To prevent accidents, never carry out auto TA and

EQ while driving. When this function measures

the car interior acoustic characteristics to create

an auto-equalizer curve, a loud measurement

tone (noise) may be outputted from the speakers.

CAUTION

! Carrying out auto TA and EQ under the follow-

ing conditions may damage the speakers. Be

sure to check the conditions thoroughly be-

fore carrying out auto TA and EQ.

— When speakers are incorrectly connected.

(e.g., When a rear speaker is connected to

a subwoofer output.)

— When a speaker is connected to a power

amp delivering output higher than the

speaker’s maximum input power capabil-

ity.

Available accessories

En

73

Section

04

Available accessories

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 96 97

Comments to this Manuals

No comments