Pioneer AVIC F900BT User Manual download pdf (Page 6)

Before installing this

product

! This product is for vehicles with a 12-volt

battery and negative earthing. Check the

battery voltage of your vehicle before instal-

lation.

! To avoid shorts in the electrical system, be

sure to disconnect the (–) battery cable be-

fore beginning installation.

To prevent damage

WARNING

! When replacing the fuse, be sure to only

use a fuse of the rating prescribed on the

fuse holder.

! When disconnecting a connector, pull the

connector itself. Do not pull the lead, as

you may pull it out of the connector.

! This product cannot be installed in a vehi-

cle without ACC (accessory) position on

the ignition switch.

A

C

C

O

N

S

T

A

R

T

O

F

F

O

N

S

T

A

R

T

O

F

F

ACC position No ACC position

! To avoid short-circuiting, cover the discon-

nected lead with insulating tape. It is espe-

cially important to insulate all unused

speaker leads, which if left uncovered may

cause a short circuit.

! Attach the connectors of the same colour

to the corresponding coloured port, i.e.,

blue connector to the blue port, black to

black, etc.

! Refer to the owner’s manual for details on

connecting the power amp and other units,

then make connections accordingly.

! Since a unique BPTL circuit is employed,

do not directly earth the * side of the

speaker lead or connect the * sides of the

speaker leads together. Be sure to connect

the * side of the speaker lead to the *

side of the speaker lead on this navigation

system.

! If the RCA pin jack on this product will not

be used, do not remove the caps attached

to the end of the connector.

! Never connect speakers with an output rat-

ing of less than 50 W channel or impe-

dance outside of the 4 ohms to 8 ohms

specifications to your navigation system.

Connecting speakers with output and/or

impedance values other than those noted

here may result in the speakers catching

fire, emitting smoke, or becoming da-

maged.

Notice for the blue lead

! A signal is output through the blue lead to

control the aerial of your vehicle. The tim-

ing varies depending on the setting. (For

more detailed information on changing

[Ant CTRL] mode, refer to “Operation Man-

ual”.)

! When [Ant CTRL] mode is set to [Radio],

the vehicle ’s aerial can be stowed or turned

off by following the instructions below.

Connecting the System

Engb

6

Section

03

1 2 3 4 5 6 7 8 9 10 11 ... 62 63

Comments to this Manuals

No comments