Pioneer VSX-1125-k User Manual download pdf (Page 63)

Using other functions

MULTI-ZONE remote controls

Set the MULTI-ZONE operation switch to

ZONE 2

ZONE

3 to operate the corresponding zone.

The following table shows the possible MULTI-ZONE

remote controls:

Making an audio or a video recording

You can make an audio or a video recording from the

built-in tuner, or from an audio or video source

connected to the receiver (such as a CD player or TV).

Keep in mind you can’t make a digital recording from an

analog source or vice-versa, so make sure the

components you are recording to/from are hooked up in

the same way (see Connecting your equipment on

page 15 for more on connections).

Since the video converter is not available when making

recordings (from the video OUT jacks) make sure to use

the same type of video cable for connecting your recorder

as you used to connect your video source (the one you

want to record) to this receiver. For example, you must

connect your recorder using Component video if your

sourc

e has also been connected using Component video.

1 Select the source you want to record.

Use the input function buttons (or INPUT SELECT).

2 Prepare the source you want to record.

Tune to the radio station, load the CD, video, DVD etc.

3 Select the input signal according to the signal to be

recorded.

Use the remote control’s SIGNAL SEL button.

4 Prepare the recorder.

Insert a blank tape, MD, video etc. into the recording

device and set the recording levels. Refer to the

instructions that came with the recorder if you are

unsure how to do this. Most video recorders set the audio

recording level automatically—check the component’s

instruction manual if you’re unsure.

5 Start recording, then start playback of the source

component.

Reducing the level of an analog signal

The input attenuator lowers the input level of an analog

signal when it’s too strong. You can use this if you find

that the OVER indicator lights often or you can hear

distortion in the sound.

• Press , then press

A.ATT

to switch the

input attenuator on or off.

Using the sleep timer

The sleep timer switches the receiver into standby after a

specified amount of time so you can fall asleep without

worrying about the receiver being left on all night. Use

the remote control to set the sleep timer.

• Press , then press

SLEEP

repeatedly to set

the sleep time.

• You can check the remaining sleep time at any time

by pressing SLEEP once. Pressing repeatedly will

cycle through the sleep options again.

Dimming the display

You can choose between four brightness levels for the

front panel display. Note that when selecting sources, the

display automatically brightens for a few seconds.

• Press , then press

DIMMER

repeatedly to

change the brightness of the front panel display.

Button What it does

 Switches on/off power in the sub zone.

INPUT SELECT Use to select the input function in the sub

zone.

Input function

buttons

Use to select the input function directly (this

may not work for some functions) in the sub

zone.

MASTER

VOLUME +/–

Use to set the listening volume in the sub

zone.

a.You can only use this button when Speaker System is set to ZONE

MUTE

Mutes the sound or restores the sound if it has

been muted (adjusting the volume also

restores the sound).

Note

1• The receiver’s volume, Audio parameters (the tone controls, for example), and surround effects have no effect on the recorded signal.

• Some digital sources are copy-protected, and can only be recorded in analog.

• Some video sources are copy-protected. These cannot be recorded.

2 The attenuator isn’t available with digital sources, or when using the Stream Direct (ANALOG DIRECT) modes.

3 The sleep timer is valid for all zones. If any zone is on, the sleep timer continues functioning.

RECEIVER

30 min

60 min

90 minOff

RECEIVER

VSX-1325_UXJCB.book 63 ページ２０１０年３月９日　火曜日　午後３時４分

1 ... 62 63 64 ... 112

Comments to this Manuals

No comments

Pioneer VSX-1125-k User Manual Page 63

Comments to this Manuals

Related products and manuals for AV receivers Pioneer VSX-1125-k