Pioneer AVH-5300DVD User Manual download pdf (Page 2)

WARNING

! To avoid the risk of accident and the potential

violation of applicable laws, no viewing of

front seat video should ever occur while the

vehicle is being driven. Also, rear displays

should not be in a location where they are visi-

bly distracting to the driver.

! In some countries or states the viewing of

images on a display inside a vehicle even by

persons other than the driver may be illegal.

Where such regulations apply, they must be

obeyed and this unit’s DVD features should

not be used.

CAUTION

! PIONEER does not recommend that you in-

stall or service your display unit yourself. In-

stalling or servicing the product may expose

you to risk of electric shock or other hazards.

Refer all installation and servicing of your dis-

play unit to authorized Pioneer service person-

nel.

! Secure all wiring with cable clamps or electri-

cal tape. Do not allow any bare wiring to re-

main exposed.

! Do not drill a hole into the engine compart-

ment to connect the yellow cable of the dis-

play unit to the vehicle battery. Engine

vibration may eventually cause the insulation

to fail at the point where the wire passes from

the passenger compartment into the engine

compartment. Take extra care in securing the

wire at this point.

! It is extremely dangerous to allow the micro-

phone lead to become wound around the

steering column or gearstick. Be sure to in-

stall the unit in such a way that it will not ob-

struct driving.

! Make sure that cables will not interfere with

moving parts of the vehicle, such as the gear-

shift, parking brake or seat sliding mechan-

ism.

! Do not shorten any cables. If you do, the pro-

tection circuit may fail to work properly.

WARNING

! LIGHT GREEN LEAD AT POWER CON-

NECTOR IS DESIGNED TO DETECT

PARKED STATUS AND MUST BE CON-

NECTED TO THE POWER SUPPLY SIDE

OF THE PARKING BRAKE SWITCH. IM-

PROPER CONNECTION OR USE OF

THIS LEAD MAY VIOLATE APPLICABLE

LAW AND MAY RESULT IN SERIOUS IN-

JURY OR DAMAGE.

Important

! This unit cannot be installed in a vehicle with-

out ACC (accessory) position on the ignition

switch.

O

N

S

T

A

R

T

O

F

F

ACC position No ACC position

! Use of this unit in conditions other than the

following could result in fire or malfunction.

— Vehicles with a 12-volt batter y and negative

grounding.

— Speakers with 50 W (output value) and

4 ohm to 8 ohm (impedance value).

! To prevent a short-circuit, overheating or mal-

function, be sure to follow the directions

below.

— Disconnect the negative terminal of the

battery before installation.

— Secure the wiring with cable clamps or ad-

hesive tape. Wrap adhesive tape around

wiring that comes into contact with metal

parts to protect the wiring.

— Place all cables away from moving parts,

such as the gear shift and seat rails.

— Place all cables away from hot places,

such as near the heater outlet.

— Do not connect the yellow cable to the bat-

tery by passing it through the hole to the

engine compartment.

— Cover any disconnected cable connectors

with insulating tape.

— Do not shorten any cables.

En

2

Section

01

Connecting the units

1 2 3 ... 76

Comments to this Manuals

No comments