Pioneer SPH-DA100 User Manual download pdf (Page 5)

02

Connecting the system

Section

5

Engb

English

To prevent damage

WARNING

Use speakers over 50 W (output value)

and between 4

Ω to 8 Ω (impedance

value). Do not use 1

Ω to 3 Ω speakers

for this unit.

The black lead is earth. Please earth

this lead separately from the earth of

high-current products such as power

amps. Do not earth more than one

product together with the earth from

another product. For example, you

must separately earth any amp unit

away from the earth of this product.

Connecting earths together can cause

a ﬁ re and/or damage the products if

their earths became detached.

When replacing the fuse, be sure to

only use a fuse of the rating prescribed

on this product.

When disconnecting a connector, pull the

connector itself. Do not pull the lead, as

you may pull it out of the connector.

This product cannot be installed in a vehi-

cle without ACC (accessory) position on

the ignition switch.

A

C

C

O

N

S

T

A

R

T

O

F

F

O

N

S

T

A

R

T

O

F

F

ACC position No ACC position

To avoid short-circuiting, cover the discon-

nected lead with insulating tape. It is espe-

cially important to insulate all unused

speaker leads, which if left uncovered may

cause a short circuit.

Refer to the owner’s manual for details on

connecting the power amp and other units,

then make connections accordingly.

•

•

•

•

•

•

•

Since a unique BPTL circuit is employed, do

not directly earth the

side of the speaker

lead or connect the

side of another side

of the speaker lead together. Be sure to

connect the

side of the speaker lead to

the side of the speaker lead on this prod-

uct.

If the RCA pin jack on this product will not

be used, do not remove the caps attached

to the end of the connector.

Notice for the blue/white lead

When the ignition switch is turned on (ACC

ON), a control signal is output through the

blue/white lead. Connect to an external

power amp’s system remote control termi-

nal (max. 300 mA 12 V DC). The control sig-

nal is output through the blue/white lead,

even if the AV source is switched off.

Be sure not to use this lead as the power

supply lead for the external power amps.

Such connection could cause excessive cur-

rent drain and malfunction.

Be sure not to use this lead as the power

supply lead for the auto-aerial or aerial

booster. Such connection could cause exces-

sive current drain and malfunction.

•

•

•

•

•

1 2 3 4 5 6 ... 144

Comments to this Manuals

No comments