Pioneer VSX-920-K User Manual download pdf (Page 77)

Controlling the rest of your system 09

77

En

English

Français

Deutsch

Nederlands

Italiano

Español

Chapter 9:

Controlling the rest of your

system

Operating multiple receivers

Up to four receivers can be operated discretely

using this receiver’s remote control when

using multiple receivers, provided they are of

the same model as this receiver. The receiver to

be operated is switched by inputting the preset

code to set the remote control setting.

• Set the remote modes on the receivers

before using this function (see Remote

Control Mode Setup on page 107).

1 Press and hold

R.SETUP

, then press “4”

for three seconds.

The LED flashes continuously.

• To cancel the preset setup mode press

R.SETUP.

2 Press the number button for the receiver

(“

Receiver 1

” to “

Receiver 4

”) you wish to

operate.

For example, to operate “Receiver 2”, press “2”.

If the LED lights for one second, the setting has

been successfully completed.

When the preset code is input, the LED flashes

three times to indicate that the setting has

failed.

Setting the remote to control

other components

Most components can be assigned to one of

the input function buttons (such as DVD or

CD) using the component’s manufacturer

preset code stored in the remote.

However, there are cases where only certain

functions may be controllable after assigning

the proper preset code, or the codes for the

manufacturer in the remote control will not

work for the model that you are using.

If you can’t find a preset code that matches the

component you want to control, you can still

teach the remote individual commands from

another remote control (see

Programming

signals from other remote controls

on page 78).

Note

• You can cancel or exit any of the steps by

pressing R.SETUP.

• After one minute of inactivity, the remote

automatically exits the operation.

• For greater convenience, assign the TV

connected to the MONITOR OUT terminal

to the TV CTRL button, and assign your

satellite/cable receiver or set-top box

connected to the TV input terminal to the

TV input button. If a single device is

connected to both terminals, that device

should be assigned to both the TV CTRL

and TV input buttons.

• Devices may be assigned to the following

input function buttons.

INPUT

SELECT ZONE 2

iPod

USB TUNER VIDEO TV CTRL

ADAPTERNET RADIO

CDTV

BD DVD

R.SETUP

SOURCERECEIVER

MULTI

OPERATION

DVR/BDR HDMI

RECEIVER

VSX-1020_SYXCN.book 77 ページ２０１０年３月１２日　金曜日　午前９時１０分

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 399 400

Comments to this Manuals

No comments