Pioneer VSX-920-K User Manual download pdf (Page 82)

Controlling the rest of your system09

With Pioneer components, you don’t need to

program the power to switch off in a shutdown

sequence (except DVD recorders).

5 Repeat steps 3 to 4 to program a

sequence of up to five commands.

Programming mode will terminate

automatically when the 5 commands are

entered.

•If you press R.SETUP before programming

is completed, commands programmed up

to that point will be stored.

Using multi operations

1Press

MULTI OPERATION

The LED flashes continuously.

Within five seconds, press

an input

function button that has been set up with a

multi operation.

The receiver switches on (if it was in standby)

and the programmed multi operation is

performed automatically.

Using System off

1 Press

MULTI OPERATION

The LED flashes continuously.

Within five seconds,

press

 SOURCE

The command sequence you programmed will

run, then all Pioneer components will switch

off

, followed by this receiver (switch of all the

zones becomes off).

Erasing the settings for the multi-

operation

This erases all the settings programmed in the

remote control for the multi-operation.

1 Press and hold

R.SETUP

, then press “8”

for three seconds.

The LED flashes continuously.

• To cancel the preset setup mode press

R.SETUP.

2 Press the input function button

containing the program you want to cancel or

the

 SOURCE

button for three seconds.

If the LED lights for one second, the erasing

has been successfully completed.

Note

1 In order to avoid accidently switching off a DVD recorder that is currently recording, no DVD recorder power off codes

are sent.

VSX-1020_SYXCN.book 82 ページ２０１０年３月１２日　金曜日　午前９時１０分

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 399 400

Comments to this Manuals

No comments

Pioneer VSX-920-K User Manual Page 82

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Pioneer VSX-920-K